Guangzhoushi Yingcai Kejiyouxiangongsi NH800UP-VOICE Remote Control User Manual
- June 5, 2024
- Guangzhoushi Yingcai Kejiyouxiangongsi
Table of Contents
Guangzhoushi Yingcai Kejiyouxiangongsi NH800UP-VOICE Remote Control
Pairing New Remote method
- Press [Power] key to turn on the [TV]
- Press and Hold the [VOL-] key and[ •·· ] key together for 3-5 seconds, the indicator light flashes and enters the pairing state. After the pairing is successful, the indicator light will go out.
Connected new remote with a Paired Remote
- Press the [Home] key, then select [Setting- Remotes & accessories]
- Select [Add accessory], then press the [OK] key to confirm to pair.
- Press and Hold the [VOL-] key and [ •·· ] key together for 3-5 seconds, the indicator light flashes and enters the pairing state. After the pairing is successful, the indicator light will go out.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by
the manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
RF Exposure Information
The device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>