hama 00 223402 Power Supply Unit Instruction Manual
- June 3, 2024
- Hama
Table of Contents
hama 00 223402 Power Supply Unit
Explanation of warning symbols and notes
- Risk of electric shock: This symbol indicates a risk of electric shock from touching uninsulated product parts that may carry hazardous voltage.
- Warning: This symbol is used to indicate safety instructions or to draw your attention to specific hazards and risks.
- Note: This symbol is used to indicate additional information or important notes
Package contents
- Car power supply unit
- 2 jack plugs: 3.5/2.5 mm
- 6 DC plugs: 0.75×2.4 / 1.0×3.0 / 1.3×3.5 / 1.7×4.0 / 2.1×5.0 / 2.5×5.5mm
- Adjusting key
- These operating instructions
Safety instructions
- When using this product, observe the applicable local traffic laws and regulations.
- Take care that components such as airbags, safety areas, controls, instruments, etc. and visibility are not blocked or restricted.
- Do not allow yourself to be distracted by the product when driving a vehicle. Always pay attention to the surrounding traffic and your environment.
- Protect the product from dirt, moisture and overheating and use it in dry environments only.
- Do not drop the product and do not expose it to any major shocks.
- Do not operate the product outside the power limits given in the specifications.
- Do not modify the device in any way. Doing so voids the warranty.
- Do not continue to operate the product if it is visibly damaged.
- Use the product only for the intended purpose.
- As with all electrical products, this device should be kept out of the reach of children.
- Do not bend or crush the cable.
- Always pull directly on the plug when disconnecting the cable, never on the cable itself.
- Do not use the product in the immediate vicinity of heaters, other heat sources or in direct sunlight.
- Dispose of packaging material immediately in accordance with the locally applicable regulations.
- Only use the article under moderate climatic conditions.
- Do not use the product in areas in which electronic products are not permitted.
- Do not use the product in a damp environment and avoid splashing water.
Risk of electric shock
- Do not open the device or continue to operate it if it becomes damaged.
- Do not use the product if the charging cable, adapter cable or power cable is damaged.
- Do not attempt to service or repair the product yourself. Leave any and all service work to qualified experts.
Operation
Note – 12 V vehicle electrical system The charger is suitable for a 12 V vehicle electrical system.
Warning – connecting devices
- Before connecting a device, check whether it can be adequately supplied with the charger’s current capacity.
- Only operate the product on a vehicle socket that has been approved for this. The vehicle socket (12V) must always be easily accessible.
- On some types of vehicle, the ignition must be switched on for the voltage to travel to the 12V vehicle socket. For more information, please refer to your vehicle’s owners’ manual.
- Disconnect all cable and vehicle electrical system connections after use.
- Note the instructions in your device’s operating manual.
Unless different instructions have been expressly given in the operating instructions for the devices you are charging, proceed as follows:
- Without connecting it to the socket, determine the mechanical compatibility between the universal power supply unit’s adapter and the connection socket on the device.
- Observe the polarity of the connection socket on the device and plus the adapter in accordingly (see Fig. 2).
- Set the voltage selector switch to the voltage required by your device using the adjusting key supplied. Do not change the voltage again during operation of the power supply unit in combination with a terminal device.
- Plug the universal power supply unit into the socket provided for it.
- The terminal device can now be used and switched on.
The product has replaceable fuse. Always replace this fuse with the same type
of fuse with the same electrical values (see Fig. 3).
Note on connection to possible devices
- Before connecting a device, check that this can be supplied sufficiently with the power supply unit’s current output.
- Check whether the device intended for mains operation is compatible with the pin assignment of the universal power supply unit. If necessary, ask the dealer who supplied your terminal device or contact your terminal device manufacturer’s support service.
Note – car battery
With some vehicles, it can happen that power continues to be supplied even
though the ignition has been switched off. You should therefore disconnect the
product from the line connection when not in use to protect your car battery
from being drained.
Care and maintenance
- Only use soft, dry towels to clean the product.
Note: Disconnect the device from the mains before cleaning and during prolonged periods of non-use.
Technical data
Car power supply unit
- Input: 12–24 V
- Output current: 2000 mA max
- Output voltages (DC): 1.5 – 3.0 – 4.5/– 6.0 – 7.5 – 9.0/– 12.0 V
- Replaceable fuse: 2A
Warranty disclaimer
Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from improper installation/mounting, improper use of the product or from failure to observe the operating instructions and/or safety notes.
Hama GmbH & Co KG
86652 Monheim/Germany
Service & Support
www.hama.com
+49 9091 502-0
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>