Huddly L1 Conference Camera incl. USB Adapter Instructions
- June 5, 2024
- Huddly
Table of Contents
Huddly USB to PoE Adapter Product and Compliance Information
Valid for H3BA HD-PGDE-0108-A1
Safety and Caution Information
Temperature This device is intended for use in ambient temperatures between 0
°C and 35 °C (32 °F and 95 °F). Avoid using or storing next to heat sources,
in direct sunlight, or outside the intended temperature ranges.
Modify
Modification to the thermal solution, device components or enclosure shall
violate regulatory compliance requirements and may induce safety hazards.
User Instructions
The USB to PoE Adapter is made to easily connect an Ethernet device to a host
computer using USB-C. The USB to PoE Adapter can also provide 37-57V DC power
to a connected Ethernet device. Power to the Adapter is provided from the USB
host or the included 5V DC adapter.
Installation
Connect the Ethernet device and the USB to PoE Adapter using minimum a Cat5e
rated Ethernet cable. Further, connect the USB to PoE Adapter to a USB host.
The status LED will light up when the USB is connected. If the LED is white,
the Adapter has sufficient power. Otherwise, if the status LED is red, connect
the included power adapter.
A wall mount bracket with double-sided tape is included. To install the
bracket, remove the tape liner and place the bracket in a suitable position,
not higher than 2m, and on a clean smooth surface.
Attach the USB to PoE Adapter to the wall mount bracket and ensure that the
unit is properly locked in position around the mounting plate. Magnetic
surfaces can generally be used to mount the USB to PoE Adapter. Optionally,
place the Adapter directly on any horizontal surface.
The USB to PoE Adapter wall bracket is designed to hold Huddly the USB to PoE
Adapter only. It should not be used as support for any additional weight.
Power
Input Minimum requirements:
USB V BUS 5V >0.5A
The USB to PoE Adapter will enable Power over Ethernet functionality when the
following input requirements are met.
USB host 5V 3A, or external
DC adapter 5V 4A
The LED will light up white when these power conditions are met.
Use only the included Mean Well SGA25I05-P3BHD or Cincon TRE25R050-35G02 VI
AC/DC adapter. Other AC/DC adapters are not supported
Output
Voltage range: 37-57V DC Maximum current: 0.35A
Recycling
At the end of life for this product, local rules and regulations shall be followed. This product is ment to be recycled, and if applicable and/or possible, should be handed in to a collection point for recycling purposes.
Regulatory Compliance Information
This product is cus marked in accordance with the requirements of the
applicable standards for Canada and the United States.
Canada
Industry Canada Statement This Class A digital apparatus complies with CAN
ICES-3 (A)/NMB-3(A).
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
United States
FCC compliance statement This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This
equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications.
Changes or modifications to the equipment not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
Australia and New Zealand
This is a Class A product. In a domestic environment, this product may cause
radio interference in which case the user may be required to take adequate
measures.
European Union
EU Single Point of Contact
Huddly AS, Attn: Compliance Karenslyst allé 51 0279 Oslo, Norway
European Union EMC Directive conformance statement
This product has been tested and found to comply with the limits for Class A
equipment according to European Standards harmonized in the Directives in
compliance. The limits for Class A equipment were derived for commercial and
industrial environments to provide reasonable protection against interference
with licensed communication equipment.
Warning: This is a Class A product. In a domestic environment, this
product may cause radio interference, in which case the user may be required
to take adequate measures.
In the European Union, this symbol indicates that this product must not be disposed of with household waste. It is your responsibility to hand it over to a designated collection point for the recycling of waste electronic equipment. For more information, please contact your local waste collection center or the point of purchase of this product.
Support
For more information visit:
www.huddly.com/support
EULA
By using this product, you agree that your use of this product is subject to
our End User Licence
Agreement terms are available at:
www.huddly.com/eula
Privacy policy Our privacy policy is available at: www.huddly.com/privacy-
policy
You can find further compliance information at:
www.huddly.com/L1/compliance
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>