Shenzhen Yinai Intelligent Manufacturing Technology CCL-001 Watch Wireless Charger User Manual
- June 5, 2024
- Shenzhen Yinai Intelligent Manufacturing Technology
Table of Contents
WATCH WIRELESS CHARGER
User Manual
PRELIMINARY OPERATIONS
Connect the cable to the Micro USB socket, and place the smartwatch on the wireless charger. If the watch is on, it indicates that the charging is in progress. At the same time, you can check the battery charge status on the smartwatch screen.
Note: for recharging your Smartwatch, WIRELESS CHARGER must be powered by an
adaptive charger or alternatively a charger with at least a 1A charge.
WIRELESS CHARGER is compatible for use with most of the cases on the market
and charging times may vary depending on the thickness of the case.
Also, make sure that there are no metallic or magnetic elements between the
Smartphone and the charger.
TECHNICAL SPECIFICATIONS WIRELESS FAST CHARGER STAND KIT
Input Voltage: DC5V from adapter
Antenna Type: Coil
Frequency band: 320-325 kHz
Shenzhen Yinai Intelligent Manufacturing Technology Co., Ltd declares that this wireless charger complies with Directive 2014/53/EU. Shenzhen Yinai Intelligent Manufacturing Technology Co., Ltd also declares that this wireless charger complies with Directive
INFORMATION ON THE STATUTORY WARRANTY
Our products are covered by a statutory warranty against conformity defects in
accordance with applicable national consumer protection
Use the watch charger only as instructed in the packaging Must be powered
using a suitable watch charger Protect the product from dirt, humidity, and
overheating and use only in dry environments, avoiding all contact with
liquids Do not expose to the sun, high temperatures, or flames If the cable is
dropped, ensure it is not damaged before using it again Keep far from the
reach of children
FCC Warning
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. This equipment has
been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20cm between the radiator& your body.
Manufacturer: Shenzhen Yinai Intelligent Manufacturing Technology Co., Ltd
Address: 6 Floor, D Building, Huamingcheng High-Tech Park, Matian Street,
Guangming Dist, Shenzhen, Guangdong, China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>