FOREST RIVER Li-BIM Lithium Battery Isolation Manager User Manual

June 5, 2024
FOREST RIVER

FOREST RIVER Li-BIM Lithium Battery Isolation Manager

Precision Circuits Inc

The Lithium Battery Isolation Manager (Li-BIM)
isolates the two battery systems, chassis, and coach, in a motorhome. This prevents loads in one system from discharging both. It also connects the two battery systems together during charging. Both batteries are charged if either is being charged. The coach battery is charged while driving and the chassis battery is charged while plugged into Shore Power at a campground.
Key Features:

  1. 160amp & 225amp continuous models available
  2. Runs cooler using less power
  3. Draws no current in ON or OFF state
  4. Excellent for Solar Panel use
  5. Microprocessor-based
  6. Monitors battery state over longer periods of time
  7. Not simply voltage-dependent
  8. Approved for Battery Compartments
  9. Ignition Proof, SAE J1171
  10.  Waterproof, IEC 60529, IP66 IP67, ASTM B 117 96 Hours Salt Spray
  11. . Charges
  12.  Lithium Coach Battery from Alternator
  13.  Lead Acid Chassis Battery from Coach Charger
  14.  Isolates Batteries to prevent discharging or overcharging of Batteries
  15. Prevents
  16.  Equalization cycles from Damaging Chassis Battery
  17.  Annoying clicking of Isolator Relay
  18.  Overcharging of Coach Battery during long drives
  19.  Overcharging of Chassis Battery during long stays
  20. Provides Emergency Start with Dash Switch. Optional power connection for existing applications, and ground connection to allow Emergency Start of either battery.
  21. Weighs under 1 pound

The Li-BIM monitors the battery voltage of both the Lead Acid Chassis and Lithium Coach batteries over long periods of time. If it senses a charging voltage, it connects the two batteries together. If the charging system is drastically overburdened, the batteries will be isolated, however, if the Li- BIM sees a long-term charging of both batteries it will allow the batteries to remain connected and allow the charging system to do its job. Once the batteries have charged for one hour, the Li-BIM will isolate the batteries to prevent overcharging, and will only reconnect the batteries for charging if one of the batteries drops to approximately 80% charge, and the other is being charged. This long-term monitoring of the batteries prevents the annoying relay clicking that exists in simpler isolation modules today. The Li-BIM does not guarantee 100% battery charge, but prevents harmful battery charge levels.

Operation

The Lithium Battery Isolation Manager opens and connects the two 5/16” copper terminals by means of sliding contact. Each time Li-BIM changes
ON/OFF state, the contact instantly switches. The Li-BIM remains in the ON or OFF state, without coil power.

2538 Wisconsin Ave, Downers Grove, IL 60515 www.PrecisionCircuitsInc.com 630-515-9100

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals