Njy Technology Weret Wireless Charger A04 User Manual
- June 5, 2024
- Njy Technology
Table of Contents
Njy -Technology- Weret- Wireless -Charger -A04
Safety
Read these simple guides. Not following them can be dangerous or illegal. Interference All wireless devices can be susceptible to interference that can affect performance. Qualified Service Only qualified personnel should install or service this product. Batteries, Chargers, and Other Accessories Use only batteries, watches, and accessories approved by the company for use with this device. Do not connect incompatible products. Keep your device dry Your device is not waterproof. Keep dry.About your wireless charger With the Wireless Charger A04, you can charge the battery of your Watch without connecting any cables to your watch. Smart features, such as alerts on foreign object detection are also included in the charger. For more info on operation and safety, see the user guide of your watch or other device. Charging instructions: It supports mobile phone chargers within 5V and computer USB ports. Putting the watch on the concave side of the charging base will automatically absorb and charge it. It takes about 4 hours for a full charge. It is fully charged when the charging icon stops.
Indicator lights
| Blue and continuous | Charging |
|---|---|
| Green and continuous | Standby/the battery of your watch is fully charged |
| Green and flashing | Over temperature error, let the watch and charger cool |
down. The charger stops charging if it reaches 44’C
Blue and flashing| Charging error, the connected power source is not able to
provide enough power
If there is a problem with charging:
- Check that no other object is on the plate.
- If the charging plate is too warm, take your watch off the plate, and unplug the plate. The plate may switch off automatically if it is too hot. When the plate has cooled down, try charging again.
- Use the charger provided in the sales box.
FCC statement
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: 1) this device may not cause harmful
interference, and 2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- consult the dealer or an experienced radio/TV technician for help. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. During the operation of device a distance of 15 cm surrounding the device and 20 cm above the top surface of the device must be respected.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>