MPOW BH437A M30 True Wireless Earbuds User Manual
- June 5, 2024
- MPow
Table of Contents
MPOW BH437A M30 True Wireless Earbuds
PACKING LIST
DIAGRAM
POWER ON
- The earphones automatically turn on(with white LED light flashing) and start pairing when you open the charging case.
- In the shutdown status and when the earphones are not in the charging case, simultaneously press and hold the MFB of both earbuds for 2 seconds to power on ( with the white LED light flashing).
POWER OFF
- Put the earphones back in the charging case and close the case to turn them off.
- If the earphones are not in the charging case.just press and hold the MFB of both earbuds for 5 seconds to power them off.
PAIRING
-
Open the charging case, they will automatically enter the pairing mode in which the LED light flashes white and red alternately, and then select “Mpow M30”.
pairing mode in which the LED light flashes white and red alternately, and then select “Mpow M30”. -
If the earphones are not in the charging case. firstly. turn on the earbuds by pressing and holding the MFB of both earbuds for 2 seconds. Next. double touch the MFB of Right earbud to enter the pairing mode in which the LED light flashes white and red alternately, and then select “Mpow M30” on your phone.
Note, The earbud will reconnect to the paired device by priority. If you want to pair to the second smartphone, please disconnect Bluetooth on the paired smartphone.
MUSIC
-
Volume Up/ Down
Volume+: press and hold the MFB button of Right earbud to tum up the volume increasingly.
Volume – : press and hold the MFB button of Left earbud to turn down the volume decreasingly. -
Next/ Previous Track
Next Track: double touch the MFB of Right earbud. Previous
Track: double touch the MFB of Left earbud. -
Play/ Pause
Touch the MFB of either earbud once.
INCOMING CALL
-
Answer/ Hang Up
Double touch the MFB of either earbud. -
Reject
Press and hold the MFB ofeither earbud for l second. -
Activate Siri
Triple-touch the MFB of either earbud.
RESET
In the state of charging, simultaneously press and hold the MFB of both earbuds for 5 seconds, The LED light will flash red, which means that the paired information is cleared successfully.
CHARGING
Do not put the earbuds in the charging case when the earbuds are wet
CORRECT DISPOSAL OF THIS PRODUCT
( waste Electrical & Electronic Equipment )
A This Marking shown on the product or its literature, indicate that it should
not be disposed with other household wastes at the end of its working life.
To prevent possible harm to the environment or human health from uncontrolled
waste disposal, please separate this from other types of wastes and recycle it
responsibly to promote the sustainable reuse of material resources.Household
user should
contact either the retailer where they purchased this product or their local
government office, for details of where and how they can take this item for
environmentally safe recycling.
Business users should contact their supplier and check the terms and
conditions of the purchase contact This product should not be mixed with other
commercial wastes for disposal.
FCC STATEMENT
Af¥Changes or modifications not expres;ly appro.ed by the par!¥ responsible
for compliance could void the users authority to operate the ecuipment
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two corditions:
- This device may not cause harmful interference, and
- this device must aa:ept any interference receMSd, including interference that may cause undesired operation.
FCC Radiation Exposure Statement:
This ecuipment complies with FCC radiation exposure limits set li:lrth for an
uncontrolled environment
www.xmpow.com
[email protected]
MPOW TECHNOLOGY CO., LTD Copyright© MPOW Inc. All rights reserved.