CRU Movedock Digital Cinema User Guide
- June 5, 2024
- CRU
Table of Contents
CRU Movedock Digital Cinema
Identifying Parts
LED Behavior
| LED Name | Color | State | Description |
|---|---|---|---|
| Drive Power | Green | Solid | The drive attached to the MoveDock is powered |
on.
Drive Activity| Amber| Blinking| The drive attached to the MoveDock is being ac-
cessed by your computer.
Installation Steps
Drive Installation Steps
- Remove the drive cover from the DX115 DC carrier.
- Carefully insert the drive into the carrier. Slide the drive toward the back of the PCA board on the back of the carrier until it clicks into place.
- Hold the drive in place and turn the drive/carrier assembly over.
- Fasten the drive into place with the four (4) screws provided with the carrier. Some drives may require minor adjustment.
- Turn the carrier back over and install the drive cover. Secure it with two (2) screws provided with the carrier.
MoveDock Operation
-
Place the MoveDock and DX115 DC drive carrier on a table.
-
Make sure that the MoveDock is switched off and not plugged in.
-
Slowly push the carrier into the MoveDock until it clicks into place.
WARNING
Failure to follow the correct insertion procedure can cause pins to be bent inside of the MoveDock and can lead to its malfunction. -
Use an included USB cable to connect the MoveDock to your computer or ingest the workstation.
-
Connect the MoveDock to power using the provided power supply.
-
Turn the power switch on the rear of the MoveDock to the on position. The green power LED will light up to indicate that the MoveDock is powered on.
Your MoveDock is now ready to use! If the attached drive is already formatted, it can be used right away. If the drive is brand new or its format is not compatible with your computer, the drive will need to be formatted before being used.
WARNING
Formatting a drive will erase all data on the drive, so be sure to back up
your data before beginning this operation.