norDISK Telemark 2.2 PU Trekking Tent Instructions
- June 3, 2024
- NORDISK
Table of Contents
norDISK Telemark 2.2 PU Trekking Tent
Installation Instruction
- Spread out the tent. Thread the pole through the color coded pole sleeve. Ensure the door is closed.
- Fix the pole ends into the webbing eyelets. Secure the tent to the ground by attaching pegs onto each guy rope ring, starting in the end and facing the wind. Pull the guy rope rings in the opposite end towards you. Erect the tent and secure with pegs
- Mount the remaining pegs to the ground. Adjust guy ropes for correct tension.
- Use poles from bonus pack to set up the entrance of the flysheet. Push the end of the pole in the webbing pocket and connect the quick hook with the guy rope loop. Now set up the Vestibule
Before Trek
Build up the tent from home and check if everything is ok. know the environment you‘ll go to (sand, hard soil, snow), and check that pegs etc. matches this consider to bring along a footprint check that the poles are ok, and if not; buy a new set before you go bring along a repair kit incl. an outer tube for poles and tape for brokens seams etc. make sure the tent is clean ensure that zippers runs smoothly (if not, get some silicone spray) if trekking in very wet conditions, seal the seams with a seam sealer, but check if it is SI or PU do not overfill your packsack as you might need the extra space during the trip optimize weight by leaving pegs, inner cabin etc. at home if it’s not needed on the trip compress the packsack as much as possible
In the Camp
Make sure you pitch on an even surface. Some models depends on this for optimal ventilation do not camp in too high grass if you want floor level ventilation remove sharp rocks and sticks that could harm the tent floor (i.e. use footprint) stretch the tent as much as possible for optimal strength and water repellency if wet or very windy, you need to re-adjust the tension of the guy ropes if very windy, use extra guy ropes and pegs for stability put the packsack somewhere where you can find it again (i.e. mesh pockets inside the tent) avoid fire and smoke near the tent – be aware of wind directions! keep an eye on guy rope tension once in a while the pack sack is a little bigger than necessary in case of an emergency pack down remove all traces from your camp
Tips & Tricks
- Adjust the cabin size by moving the ring on the center webbing
- Make sure the ventilations in both ends are free of grass and other stuff for optimal ventilation
- When you build your tarp, make sure you leave in the corner pole in the door side (foot end).
- You can open the door from the top also, for better ventilation.
- Make sure the tension of the tent is optimal, for the best climate in the tent.
- You can erect the outer tent, without the inner tent (as a shelter)
- You can add extra guy rope to the straps on the pole channel for extra strength in harsh winds.
- Notice the Telemark comes with an integrated pack sack, so no pack sack to loose anymore.
- The pack sack is made a little bigger than necessary in case of an emergency pack down.
Nordisk Company A/S
Papirfabrikken 74
DK 8600 Silkeborg
Denmark
info@nordisk.de
Tel. +45 73 73 40 00
Documents / Resources
|
norDISK Telemark 2.2 PU Trekking
Tent
[pdf] Instructions
Telemark 2.2 PU Trekking Tent, Telemark Tent, 2.2 PU, Trekking Tent, Tent, 2.2
PU Tent, Tent
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>