norDISK Halland 2 PU Instruction Manual

Table of Contents

norDISK-Halland-2-PU-product

Congratulations!
We wish you lots of fun with your new Nordisk tent.

Spread out the tent. Slide the poles through the color-coded pole sleeves. Ensure all doors.
Fix the pole ends into the webbing eyelets on the outer tent.
Secure the tent to the ground by attaching pegs into the webbing loops only at one end of the tent, starting with the end facing the wind.
Secure the tent to the ground by attaching pegs into the webbing loops only at one end of the tent, starting with the end facing the wind.
Secure the tent by attaching the guy ropes to the ground. Depending on weather conditions judge how many guy ropes are needed. In stormy weather, the tent must be securely anchored Adjust webbings and guy ropes for correct tension. Mount the inner cabin in the O-rings and hooks. When you pack the tent, you can choose to leave the inner cabin attached.

build up the tent from home and check if everything is ok.
know the environment you‘ll go to (sand, hard soil, snow), and check that pegs, etc. match this.
consider bringing along a footprint.
check that the poles are ok, and if not; buy a new set before you go bring along a repair kit incl. an outer tube for poles and tape for broken seams, etc.
make sure the tent is clean.
ensure that zippers run smoothly (if not, get some silicone spray).
if trekking in very wet conditions, seal the seams with a seam sealer but check if it is SI or PU.
do not overfill your packsack as you might need the extra space during the trip.
optimize weight by leaving pegs, inner cabin, etc. at home if it’s not needed on the trip.
compress the packsack as much as possible.

make sure you pitch on an even surface. Some models depend on this for optimal ventilation.
do not camp in too high grass if you want floor-level ventilation.
remove sharp rocks and sticks that could harm the tent floor (i.e. use footprint).
stretch the tent as much as possible for optimal strength and water repellency.
if wet or very windy, you need to re-adjust the tension of the guy ropes.
if very windy, use extra guy ropes and pegs for stability.
put the packsack somewhere where you can find it again (i.e. mesh pockets inside the tent).
avoid fire and smoke near the tent – be aware of wind directions!
keep an eye on guy rope tension once in a while.

keep it clean by hosing it after use, if very dirty. But don’t use high pressure.
clean it with a soft sponge.
use no harsh chemical cleaning or machine washing.
keep it dry, and if packed down wet, remember to dry it as soon as possible remember that a wet tent is heavier than a dry one.
check guy ropes and pegs once in a while, and buy new ones if damaged.
if you have damaged poles, your local Nordisk dealer can supply new ones.
be aware that long exposure of sunlight can degrade the fabric.
if you want floor in your apsis, you can purchase a tailored footprint.
love and nurse your tent. If you protect your tent, it will protect you.

When you open a door, you can fold and store it, in the mesh pockets found near the door.
You can adjust the height and the ventilation, just by pulling the webbings found near the poles.
You do not have to use the inner cabin in the tent – it can be pitched just as a shelter.

You can find more information onNordisk.eu

Scan it!
For 360° View, Windtest, How to pitch & Fact sheet norDISK-Halland-2-PU-
fig-7