SKIPOO B07P5RJDDT Cat Flap User Manual

SKIPOO B07P5RJDDT Cat Flap

Cat Flap Diagram

Product Overview

1. Front door frame
2. Back door frame
3. Screws
4. Double-sided tape
5. Screw caps

Operating Instructions

4 way-locking

1. The arrow is pointed at the lock position and is completely closed.
2. The arrow is pointed at the cat outside the door and can’t enter
3. The arrow is pointed at the cat inside the door and can’t go outside.
4. The arrow is pointed at the circular position and is completely open.

Installation Cat Flap

Required: Pencil, Ruler, Electric saw, Drill and Screwdriver.

1. Define the position of the cat flap
   and mark this position with a pencil.

2. Drill holes (12mm) in all the corners
   and cut out the hole with an electric saw.

3. If the tunnel is too thick, use a cutting machine to cut through the tunnel along the line A or B.

4. After the hole is cut out, use
   sandpaper around the edges.

5. Place the cat flap in position by using double-sided tape. Put the screws in place and tighten them with a screwdriver.

6. Place the screw caps on the screw holes and press on them.
   The Skipoo cat flap is now ready for use!

Matters Need Attention

1. If the front door is not a solid wooden door or it is a composite door, please prepare a wooden strip in advance to block the doorway.
2. Remember to protect the front of the cat flap during installation to prevent scratches.
3. If the outdoor temperature is below minus 20 degrees Celsius, please attach protective film on the cat flap to prevent it from breaking.
4. Always were safety goggles during installation.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>