Kensington 005640515 Presenter Expert Green Laser Presenter with Cursor Control User Guide
- June 5, 2024
- Kensington
Table of Contents
005640515 Presenter Expert Green Laser Presenter with Cursor Control
User Guide
Register Now!
Getting Started
On/Off switch
Mode switch
LED Indicator
| Power On | Red on (3 sea) |
|---|---|
| Laser On | Green On |
| Low Battery | Red Blinking |
Presentation Mode
Mouse Mode
CAUTION! IMPORTANT SAFETY INSTRUCTIONS
The Presenter Expert™ Green Laser Presenter includes a built-in laser pointer. Therefore, as with any laser pointer, it is important to adhere to the following warnings and safety instructions to prevent injury:
- Never shine a laser pointer into a person’s eyes, or stare into the laser beam. Pointing a laser pointer into a person’s eyes, or staring directly at the laser beam, can cause instant temporary vision dysfunction such as flash blindness, disorientation, or glare. This can be particularly dangerous if the exposed person is engaged in a vision-critical activity such as driving. In addition, prolonged and/or repeated exposure to the laser beam can be hazardous and damaging to the eyes.
- Never aim a laser pointer anywhere on any or person or animal. Laser pointers are designed to illustrate inanimate objects only. In some states and provinces, it is illegal to aim a laser pointer on a law enforcement officer or on any other person. The purchaser/user is responsible for ensuring that his or her use of the laser pointer conforms to any local laws.
- Do not point a laser pointer at mirror-like surfaces. A reflected beam can act like a direct beam on the eye.
- Laser pointers are not toys. Do not allow a minor to use a pointer unsupervised. In some states and provinces, it is illegal for a minor to purchase and/or use a pointer. The purchaser/user is responsible for ensuring that his or her purchase or use of the laser pointer conforms to any local laws.
Technical Support
Technical support is available to all registered users of Kensington products. There is no charge for technical support except the cost of the phone call, and long-distance charges where applicable. Technical Support Contact information can be found on the back page of this manual.
Technical Support Tips
- You may find the answer to your problem in the Frequently Asked Questions (FAQ) section of the Support area on the Kensington Website: www.support.kensington.com.
- Call from a phone where you have access to your device
- Be prepared to provide the following information:
– Name, address, and telephone number
– The name of the Kensington product
– Symptoms of the problem and what led to them
FCC RADIATION EXPOSURE STATEMENT
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. End-users must follow the specific operating
instructions for satisfying RF exposure compliance. This transmitter must not
be co-located or operating in conjunction with any other antenna or
transmitter.
CLASS 2 LASER SAFETY STATEMENT
This laser device complies with International Standard IEC/EN 60825-1: ED 2.
2007, Class 2 Laser
Product and also complies with 21 CFR 1040.10 and 1040.11, except for
deviations pursuant to Laser Notice No. 50, dated June 24, 2007:
- Emission of a parallel beam of visible light;
- Maximum Power of 1 milliwatt CW, wavelength range 532±10 nanometers;
- Operating temp between 0 ° C (32° F) to 40° C (104° F).
• Do not disassemble the device
• Do not use the device outside of its specified operating temperature range. If the device is exposed to an environment outside of its prescribed operation, turn off the device and allow the temperature to stabilize within the specified operating range before using the device.
CAUTION!
A set of warning labels in different languages is provided with this product.
It is essential that the correct country-specific warning label is applied to
the laser pointer for the safety of the user and of the people nearby.
CAUTION!
This device has no serviceable parts. Use of controls or adjustments or
performance of procedures other than those specified herein may result in
hazardous radiation exposure.
FEDERAL COMMUNICATIONS COMMISSION RADIO FREQUENCY INTERFERENCE STATEMENT
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
MODIFICATIONS: Modifications not expressly approved by Kensington may
void the user’s authority to operate the device under FCC regulations and must
not be made.
Operating Frequency Range: 2.402GHz to 2.478GHz
Maximum RF Output Power: 0.0 dBm
FCC DECLARATION OF CONFORMITY COMPLIANCE STATEMENT
This product complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation. As defined in
Section 2.909 of the FCC Rules, the responsible party for this device is
Kensington Computer Product Group, 333 Twin Dolphin Drive, Redwood Shores, CA
94065, USA.
INDUSTRY CANADA CONFORMITY
This Class B digital apparatus complies with Canadian ICES-003.
This device has been tested and found to comply with the limits specified in
RSS-210. Operation is subject to the following two conditions: (1) This device
may not cause interference, and (2) This device must accept any interference,
including interference that may cause undesired operation of the device.
CE DECLARATION OF CONFORMITY
Kensington declares that this product is in compliance with the essential
requirements and other relevant provisions of applicable EC directives.
For Europe, a copy of the Declaration of Conformity for this product may be
obtained by clicking on the Compliance Documentation link at
www.support.kensington.com
THE FOLLOWING INFORMATION IS ONLY FOR EU-MEMBER STATES:
The use of the symbol indicates that this product may not be treated as
household waste. By ensuring this product is disposed of correctly, you will
help prevent potential negative consequences for the environment and human
health, which could otherwise be caused by inappropriate waste handling of
this product. For more detailed information about recycling this product,
please contact your local city office, your household waste disposal service
or the shop where you purchased the product.
Kensington and the ACCO name and design are registered trademarks of ACCO
Brands. The Kensington Promise is a service mark of ACCO Brands. Presenter
Expert is a trademark of ACCO Brands. All other trademarks are the property
of their respective owners.
© 2012 Kensington Computer Products Group, a division of ACCO Brands. Any
unauthorized copying, duplicating, or other reproduction of the contents
hereof is prohibited without written consent from Kensington Computer Products
Group. All rights reserved. 09/12
Para consumidores no Brasil
Technical Support
| Australia | 1300 881 931 |
|---|
Kensington Computer Products Group
A Division of ACCO Brands
333 Twin Dolphin Drive, Sixth floor
Redwood Shores, CA 94065
ACCO Brands Europe
Oxford House
Oxford Road
Aylesbury
Bucks, HP21 8SZ
United Kingdom
ACCO Brands Canada
5 Precidio Court
Brampton
Ontario, L6S 6B7
Canada
ACCO Australia
Level 2, 8 Lord St
Botany NSW 2019
Australia
Designed in California, U.S.A. by Kensington
Made in China
References
- Re-direct | Kensington
- Computer Products & Accessories: Locks & Docks | Kensington
- Product Support - Support - Kensington
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>