Followme GV20 Vehicle GPS Tracker Installation Guide
- June 5, 2024
- Followme
Table of Contents
QUICK INSTALLATION GUIDE
GV20
Hardware Description
Version 1.0
Updated: 4 March 2021
Please carefully read the user guide before use in order to avoid damage and quickly get the device to operate. Product appearance, color, and accessories are subject to change without prior notice in this manual
Product Specifications
Product Specification
Size| 85 mm x 45 mm x 13 mm
Weight| 60 g
Battery| 450 mAh High-Temperature Battery
Standby time| 24 hours
Power In| 9 — 36 V DC
Networks| WCDMA 850/900/1900/2100MHz GSM 850/900/1800/1900MHz
SIM Type| FULL / LARGE SIM
Location Accuracy| < 10 meters
Working temperature| -20 Deg C to +70 Deg C
Waterproof| IP65
LED| Green| GSM/GPRS indicator
Blue| GPS indicator
Red| DC Power
– Please connect DC power with correct Polarity. Incorrect polarity may damage
the tracking device and void the warranty.
– Use Full / Large SIM for the device.
– Activate Prepaid SIMs before using the device.
– Remove PIN number from SIM before using.
Installation Instructions
Open the Device
Note:
- Please power off the device before installing or removing the SIM card.
- Open the cover 2) Insert the SIM card correctly
Pull the lid to open the device
2.2 LED indicators
GPS LED Indicator- Blue
Flashing (interval 0.1s)| Searching BD/GPS signal
Solid blue| BD/GPS positioned
OFF| GPS sleep or off
GSM LED Indicator – Green
Quick flashing| GSM initializing
Slow flashing| Receive GSM signal normally
Solid green| Connected to GPRS network
OFF| No GSM signal or SIM card
Wiring
Vehicles| 
Boats
---|---
(If Engine start notification is required, follow Vehicle wiring – But Not recommended)
Switch ON the device.
The tracking device switches ON automatically when connected to DC Power. But
always make sure the Power on/off switch is at the ON position. This will use
an internal battery to run the device if external DC power fails.
Close the Cover
Use the 3M cotton stick (provided) to fix the device.
The light sensor should face down| Fix the device as shown. An incorrect
position may reduce the GPS signal
---|---
Fixing the device on Boats
| Speed Boats | Fishing Dhoni |
|---|
|
- Fix the tracking device at the highest location possible, inside the boat away from metal surfaces, electric wiring, etc.
- A recommended location for a speed boat is near the VHF set where the DC power is available (marked by a circle)
- Keep the tracking device faces up for better GPS reception.
Cable Details
| Wire Color | Name | Description |
|---|---|---|
| RED | BATTERY + | 9 to 36V DC input power (BATTERY + / plus) |
| BLACK | GND | BATTERY – (minus) |
| ORANGE | IGNITION | Connect Battery +ve with RED wire or connect to Engine |
Starter key
YELLOW| RELAY| NOT USED
Contact us on 7901617 for any assistance required.
www.followme.mv,
info@followme.mv
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>