tp-link HS200 Smart Wi-Fi Dimmer Switch User Guide
- June 5, 2024
- tp-link
Table of Contents
tp-link HS200 Smart Wi-Fi Dimmer Switch User Guide
Product Introduction
Built-in motion and ambient light sensors work together to realize hands-free control. Kasa smart dimmer switch turns on and dims the lights automatically, saving you effort and electricity bills.
Wire Your Switch
- Turn off the circuit breaker and remove the old wallplate. Then label the wires.
Ground : Usually green or copper.
Neutral : Usually white and not connected to a dumb switch.
Line : Usually black and coming from the circuit breaker.
Load : Usually black. One end is connected to the light. If you are
unsure, consult a qualified electrician.
-
Disconnect the wires.
-
Connect the wires to the smart dimmer switch as shown below.
-
Secure the dimmer switch with screws.
Set Up Your Switch
(STEP 1) DOWNLOAD APP
Get the Kasa Smart app from the Apple App Store or Google Play.
http://www.tp-link.com/common/promos/app_kasa.html?ref=QRCode
(STEP 2) SET UP
Tap the button in the app and select Smart Switches. Then follow the step-by-
step app instructions to set up your smart dimmer switch.
Button Explanations
LED Status
Specifications
Rating: 120V~ 60Hz
Load: 300W Incandescent, 150W LED
Operation temperature: 0~40
Safety Notice
Before installing, servicing or removing the switch, read and follow all safety precautions including the following: ·
- CAUTION Risk of Electric Shock More than one disconnect switch may be required to de-energize the equipment before servicing. A circuit breaker which disconnects the Line and Neutral conductor simultaneously is suitable. Ensure power is off at the circuit breaker before removing or installing any switch. Use a non-contact voltage tester to ensure the power is off.
- The Smart Switch must be installed and used in accordance with the National Electric Code (NEC) or your local electrical code. If you are unfamiliar with these codes and requirements, or are uncomfortable performing the installation, consult a qualified electrician.
- Do not install the Smart Switch with wet hands or when standing on wet or damp surfaces.
- Install only in a suitable UL Listed outlet box (suitable dimensions: H > 2.95 in./75 mm, W > 1.81 in./46 mm, D > 2 in./51 mm).
- Tighten terminal screws to 13 lbf-in.
Need some help?
Visit www.tp-link.com/support for technical
support,
user guides, FAQs,
warranty & more
7106509177 REV1.0.0 ©2021 TP-Link
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>