FLUID POWER Manual Firmware Update for iOS using nRF Connect Instructions
- June 5, 2024
- FLUID POWER
Table of Contents
FLUID POWER Manual Firmware Update for iOS using nRF Connect Instructions
Using Instructions
-
Download the nRF Connect for Mobile app from the Apple App Store HERE
-
Download the attached firmware update file to your mobile device from our website (or link sent separately in an email)
-
Enable Bluetooth on your mobile device then open the nRF Connect app
-
Power on your Fluid Rower console – the following 2 steps are only required for pre July 2021 firmware.
- Press and hold the UP and DOWN buttons for 3+ seconds
- When you see the above display, click the UP button – This puts the console into Bluetooth Connect Mode
-
Go back to the nRF Connect App. If your device is not listed, click SCAN
-
Your console device should be listed as shown (XXXX or Rower XXXX). Click CONNECT on the app screen.
-
Your console is now connected to the app by Bluetooth
-
On the App screen click the DFU tab and locate the firmware update file on your mobile device.
-
Click Start to begin the update.
- Note – this may take a minute or so. The console screen will go blank while the process is ongoing, and the device will reboot once the update is complete.
- Note – this may take a minute or so. The console screen will go blank while the process is ongoing, and the device will reboot once the update is complete.
-
Check the console firmware version, shown when console is powered on.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>