red dot INOKIM OX Electric Scooter User Guide
- June 5, 2024
- red dot
Table of Contents
red dot INOKIM OX Electric Scooter
User Guide
Congratulations On Your New INOKIM OX!
We are happy you chose to ride INOKIM.
We hope you find it to be a great riding experience, adding efficiency and fun
to your daily commuting.
A note from the designer:
When I started designing my first electric scooter, I envisioned a world where
cars are used for long-range distances only, while lightweight personal
electric devices become the primary way of transportation in urban
environments.
After seven years of sales design and development of Quick, LIGHT & MINI
scooters, we found the need for a more powerful scooter. Our aim was to
provide a good solution for heavier riders, longer range and climbs in both
urban & off-road surroundings.
We created OX to be an integrated part of your life.
Enjoy, ride carefully and return home safely.
DISCLAIMER
MYWAY NINGBO INTELLIGENT TECHNOLOGY WILL NOT BE HELD RESPONSIBLE FOR ANY
SPECIAL, CONSEQUENTIAL, OR INCIDENTAL DAMAGES CAUSED BY THE USE OR MISUSE OF
OUR PRODUCTS.
THE USER AGREES TO ACCEPT FULL RESPONSIBILITY FOR ALL SUCH RISKS AND TO NOT
HOLD MYWAY NINGBO. ITS DISTRIBUTORS OR RETAILERS ARE RESPONSIBLE FOR ANY
INCIDENT, INJURY TO PERSONS, OR DAMAGE TO PROPERTY CAUSED BY MISUSE OF THE
PRODUCT
WHY READ THIS MANUAL?
Understanding your new INOKIM features, performance, proper use & maintenance, will help you:
ENJOY
the most from your first and every ride. RIDE SMART
For the safety of yourself and your surroundings. MAINTAIN YOUR INOKIM
For many years of safe and fun riding.
SAFETY REGULATIONS
WARNING
It is prohibited to ride in poor weather conditions:
Never ride in rain, snow, icy road, wet dirt road, water, poor visibility or
other bad weather conditions.
Always wear a helmet. Most serious injuries that occur while riding are
head injuries. This can be prevented if a helmet is worn. You must wear a
helmet while riding your OX. The helmet must be worn according to its
instructions.
Follow the local laws and regulations. Certain countries or regions
require safety devices or gear.
It is your responsibility to know the state laws, and follow them.
Firmly lock the folding lever and check your brakes before every ride.
Do not do stunts, wheelies or jumps. They increase your chances of injury
and might damage your OX.
Do not carry passengers.
Make your first ride with INOKIM OX in a remote location, without any
obstacles.
SPECIFICATIONS
MODEL| OX ( Hero | Super | Eco )
---|---
Lithium Battery| 60V 13AH (Hero) | 60V 21AH (Super) | 48V 13AH (Eco)
Net Weight (+-0.5 kg)| 26 kg (Hero) | 28 kg (Super) | 25 kg (Eco)
Rang (Eco mode)| 60 km (Hero) | 110 km (Super) | 58 km (Eco)
Range (Full speed mode)| 50 km (Hero) | 90 km (Super) | 46 km (Eco)
Eco mode is with constant speed of 15 km/H,Full speed mode is with constant
speed of
25 km/H, 75 kg load, in temperature of 25°C, on a flat road condition
Charging Time (H)| 8 hours (Hero) | 12.5 hours (Super) | 7 hours (Eco)
Motor| 1000W gearless – peak 1300W (Hero|Super)
700W gearless – peak 1100W (Eco)
Speed| 25 km/H
Brake| Front drum brake, rear disk brake
Tire Size| 10 x 2.5 inch pneumatic tires, optional to
equip 10 x 3 inch off road pneumatic tires
Tire Air Pressure| 40 psi to 50 psi
Folded Size L x W x H (cm)| 122 x 59 x 54 cm
Open Size L x W x H (cm)| 122 x 59 x 130 cm
Load Limit| 120 kg
Road lighting| Integral car LED lights
Throttle| LCD display with functions and illumination
Recommended air pressure in tires: 40 psi to 50 psi.
WEIGHT
26-28 kg 25 kg| RANGE
60-110 km 46-58 km| TOP SPEED
25 km/h| MAX LOAD
120 kg| CHARGE TIME
7-12.5 hrs. for full charge
---|---|---|---|---
* Up parameter Hero & Super model | Down parameter Eco model
UN-BOX YOUR OX!
Are you ready to set your OX free?
Please follow these instructions:
-
While folded, stand the OX on kickstand.
Push down rear end of OX to release the SNAP LOCK.
-
Fasten the RED lever.
-
Set the handle bar in place.
Use the hex key (4mm)
-
Adjust the brakes angle according to your height.
A good indication for your suited angle is that your wrists are straight when you ride. -
Connect the rear mudgaurd.
Use hex key (5mm) -
When folding simply snap the steering rod into place.
-
If the SNAP LOCK of your OX is too loose / tight, you can height of the locking hook.
Use hex key (2.5mm)
BATTERY
Your OX has a Lithium Battery with an external charger.
When charging, connect the charging cable in this order:
FIRST to INOKIM’s charging socket
THEN to the electrical outlet.
Charging Indication:
RED light – Battery charging…
GREEN light- Charging complete
MAXIMIZE YOUR BATTERY’S PERFORMANCE:
-
For its initial charge, FULLY charge your OX.
This conditions the battery for future life-span. -
Do NOT leave a fully charged battery connected to a charger, since overcharging may shorten it’s lifetime.
-
Avoid extreme temperatures. Always try to keep the battery between 15°c and 25°c (59°F and 77°F). Extreme temperatures reduce the capacity and lifetime of the battery. A device with a hot or cold battery may not work temporarily
-
At least once a month fully charge the battery.
-
From time to time discharge the battery by riding.
Use all stored energy in the battery. -
Before storing it for a long period charge the battery half way.
BATTERY SAFETY REGULATIONS:
Keep the battery away from children & pets.
Exposure to the battery voltage can cause death or serious injury.
Unplug the battery from the outlet before performing any maintenance.
It is dangerous to work on an INOKIM Scooter when plugged into an electrical
outlet. Electrical shock can cause serious injury and damage the scooter.
Do NOT use the scooter if the battery:
- Is damaged
- Emits an unusual odour or excessive heat
- Presents any leakage
Do not operate the scooter while charging!
Charge the battery only using INOKIM’s approved charger.
The use. storage or charging of the INOKIM battery outside specified limits
may result in the annulment of the warranty, battery damage, and an
ineffective battery charging.
DO NOT CUT, OPEN, CRUSH OR PUNCTURE BATTERIES.
IN THE EVENT OF A BATTERY LEAK, PREVENT BATTERY LIQUID CONTACT WITH SKIN OR
EYES. IF THIS HAPPENS, FLUSH THE AFFECTED AREAS IMMEDIATELY WITH WATER, OR
SEEK MEDICAL HELP.
THROTTLE OPERATION
THROTTLE BUTTONS INTRODUCTION
WAITE UNTIL LCD DISPLAY STOPS FLASHING BEFORE YOU START RIDING.
POWER ON| To power on the scooter: press
Wait until the LCD display stops flashing before you start riding
---|---
POWER OFF| To shut down the system: press for three seconds
AUTO-OFF| After 10 minutes of not using any function, the scooter will
automatically shut down
ACCELERATION| To accelerate: gently press the thumb lever.
The OXO is powerful so be careful!
| This function is to limit the full speed of the scooter for beginners or
for more accurate riding in a crowded surroundings.
The mode can be changed with the buttons
| Your TRIP distance since your last trip reset.
Reset TRIP by long press
To swap to ODO and battery voltage: press
| Your scooter’s total distance since its factory assembly
| Your current battery voltage status
LIGHTS FUNCTION
| To turn the front and rear lights on long press
The LCD back-light indicates that the lights are on.
The lights will turn on automatically if the ambient (You can set it in mode
5, p.15)
Your system has encountered an error, please contact you’re local dealer to
find out what it is
DISPLAY MODE SETTINGS
Navigate easily through the settings:
Enter settings (mode1): Press together for 2 seconds.
Switch between modes: Press
Return to main function menu: Long press
LCD BACK-LIGHT
Mode 1| There are 3 levels for LCD brightness: low/medium/high.
To change the level from 1 to 3: Press
Long press to save setting.
Short press to enter Mode 2
---|---
SPEED LIMIT MODE
Mode 2| Default and highest speed: 25km/h at full throttle.
To change the speed limit number: Press or
Long press to save setting.
Short press to enter Mode 3
CRUISE CONTROL
Mode 3| While riding at any same speed for more than ten (10)
seconds, the Cruise Control will be turned on.
When Cruise Control is operated, you can release your thumb from the throttle
and the scooter will continue to ride at full speed.
The default for safety reasons: Cruise Control Off (“n” indicates no Cruise
Control).
To Enable Cruise Control: Press or (“Y” indicates yes Cruise Control).
Long press to save the setting.
Short press to enter Mode 4
WARNING
Please be aware that when using Cruise Control,
RELEASING YOUR THUMB FROM THE THROTTLE
WILL NOT SLOW YOU DOWN!!!
2 ways to exit Cruise Control:
- Brake with the LEFT or RIGHT brake lever (both work)
- Press the thumb lever again.
If you choose to set your Cruise Control to ON. It’s very important you practice your exit so that is comes naturally!
KM / MILE
Mode 4| Default Setting: km/h (“0” indicates km).
Press or alternate to a mile (“1” indicates mile)
Long press to save setting.
Short press to enter Mode 5
---|---
PHOTOCELL
Mode 5| The throttle has light sensors that detect the photographic Default
Setting: Photocell On (“Y” indicates yes)
To disable photocell Press or (“n” indicates no)
To adjust the light level – When letter is “Y” press
Default value: 510 Press or turn up/down the value.
Long press to save setting
THE OXO SUSPENSION ADAPTERS PATENT
The OXO has a unique patent on the adjustable suspension system.
The OXO Suspension Adapter Patent: OSAP
The OSAP allows you to alternate the suspension position:
LOW POSITION is the default, for better stability mainly at higher speeds
HIGH POSITION is for larger suspension travel, mainly in rough terrain
REPLACING OSAP FROM HIGH TO LOW
In order to turn your OXO into LOW POSITION use the LOW POSITION kit:
It is recommended that you place the OXO on an uplifted surface such as wheels
are in the air
Remove the rubber caps and use the 19 mm socket spanner to release the
suspension arms from their location
Once the suspension arm is out of its place, replace the OSAP from LOW to HIGH
in each suspension arm. Keep front and rear OSAP in their respective places.
Assemble back in reverse order. You can use the sketch below for assistance
CAREFUL RIDING
Get to know your OX before driving it. Test your control over it. Make
your turns slowly and cautiously, and give yourself stopping distance.
To gain control over your scooter, practice your first ride on OX in an open
space with no obstacles to disturb you.
The OX requires a short adjustment and break-in period for all moving
parts to adjust themselves into their correct position
Before each ride always:
-
Check your brakes function.
-
Check the tires for signs of wear –
Spin them to make sure that they are not yet in need of replacing.
Make sure that the wheels are freely rotating from the brakes. -
Perform a visual inspection :
That all screws and nuts are tight and in place.
Note if anything looks amiss, or is showing signs of wear.
If you are unsure, bring your OX to the authorized distributor.
RIDING TECHNIQUE:
Before riding position your foot as close as possible to the front
section of the scooter, and your other foot on the ground. Make sure that your
driving route is clear.
To start riding, boost yourself forwards (as on non-motorized scooters)
with your foot that is on the ground. Immediately after, place your other foot
on the scooter and press the thumb button downwards, tilting your body
forwards so you won’t fall backwards during acceleration.
As you accelerate, lean forwards.
As you brake, tilt your weight backwards!
Avoid putting your body pressure on the handle bars in acceleration and
deceleration!
Keep one foot behind the other, (it’s more comfortable to place one foot
forward and the other one turned backwards at 70-90°, like on skate/
surfboard). It will help you gain more stability.
Turns – The turns on INOKIM are done as on surf/ski/snowboard. The
handlebar should be in parallel to the body. Before turning look at the
approaching direction and make sure turning is safe.
Braking – Tilt your weight backwards so that the brake action will come
through the feet and not through the handlebar and steering system.
It is best to learn how to adjust the centre of gravity while stopping,
otherwise there is a dual concern: forward turning over and/or wear and
breaking of the handlebar and steering system.
****Riding, like most sports, involves risks of injury and damage. By choosing to ride INOKIM the responsibility and all inherent risk is on you. It is crucial that you know, understand and act according to safety rules.
FOLDING MECHANISM ADJUSTMENT
If the folding mechanism is too loose or too tight, you can adjust it.
The Tools you’ll need:
Hex key 4mm
Wrenches 8mm 10mm
The adjustments needed are VERY small.
Work sensitively, be patient and you’ll get it right!
To Tighten:
- Using the hex key turn top screw – counter clockwise by half a turn (to loosen it).
- Then use the wrench and turn 10mm bolt – clockwise by half a turn (to lower it).
- Now turn 8mm bolt – clockwise and tighten it to bolt 8mm.
- Test the function and only then, tighten back top screw.
To Loosen:
Follow the same steps, but turn the crews in the opposite direction.
SERIAL NUMBER
Each INOKIM has a unique serial number.
These numbers can provide information that may be useful later on for
insurance claims and in case of loss or theft.
Write down the serial number of your OX scooter.
Keep this information separately and in a safe place!
The number is on the BOTTOM REAR SIDE of the board
Join/create INOKIM RIDERS in your city!
OPERATION & MANAGEMENT
NINGBO MYWAY INTELLIGENT TECHNOLOGY CO., LTD.
17# PUTUOSHAN ROAD, BEILUN, NINGBO,
ZHEJIANG PROVINCE, CHINA 315806
WWW.INOKIM.COM |
GLOBAL@INOKIM.COM
LIKE A STAR
Send us a pic of YOU & YOUR INOKIM
We’ll make it into a SHINING poster.
By the end of the year the one
who has the most likes wins a
S U P R I Z E
WWW.INOKIM.COM
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>