Electrolux ETG735GK Table Top Gas Cooker Instruction Manual

Electrolux ETG735GK Table Top Gas Cooker Instruction Manual

Instruction manual

Please read the instruction manual carefully before using and keep it for future reference and maintenance. This manual contains important message, includes safe operation and special notes, structure diagram, main technical data, installation instruction, operation steps and adjustment ways, clean and maintenance, and troubleshooting.

SAFE OPERATION AND SPECIAL MOTES

1. Check the gas type and pressure before using, making sure there were accord with the marks in the label, where be stuck on the side of the stove, do not use it if the gas type and pressure is conflicting. (Do not use high pressure gas)
2. Keep the kitchen ventilates when using, there should have air entrance hole and opening exhaust appliance. (Ventilate fan or range hood)
3. There are forbidden putting flammable and explosive things around the stove.
4. Do not touch the burner cap, trivet and surface plate, etc., When using or just falme out to avoid scald.
5. Shut off gas apply, open windows and doors to keep ventilation first when gas leakage or strange smell be found, must not use any electric appliance or operate any electric switch to avoid accident.
6. If accidental flame out happened when using, shut off knob of stove to avoid leakage.
7. Adults should be presented when using( like kitchen)
8. For the sake of safe operation, avoid leakage caused by aging, the hose should be changed per year. 9. Shut off knob(s) of stove and valve of gas supply after using,

USE ONLY LOW PRESSURE REGULATOR MAX 30mbar FOR THIS APPLIANCE.

STRUCTURE DIAGRAM

MAIN TECHNICAL DATA

INSTALLATION INSTRUCTION

1. Open the box, take out the polyfoam, and put it on the even ground, remove and abandon the poly bag.
   WARNING
   BE CAREFUL WHEN YOU ABANDON THE POLY BAG IF IT IS ACCESSIBLE FOR CHILDREN. IT IS NOT A TOY FOR CHILDREN
   

2. Take out the gas stove, and put it upside down on the polyfoam, take out the legs, knob sets and burner caps (for ETG725GK&ETG735GK) bag, release the trivets by unfasten the ties.

3. Install four legs on the four square yard by nuts as followings show.
   

4. Take the stove back to normal position, and install the knob as following steps.
   

5. Remove the fasten ties on the burner cap, and put the center burner cap on right side burner of item ETG725G, and put the center and mid burner cap on right side and mid burner of ETG735GK.
   

6. Put the trivet on right position

7. Take off the dust proof cap of the gas inlet which located at the back side of the stove , connect the gas pipe to the inlet, then fasten the connection by turning the clamp clockwise..
   
   WARNING: MAKE SURE THE SUPPLIED GAS AND PRESSURE IS THE SAME AS LABEL MARKED, DIFFERENT GAS TYPE AND PRESSURE WILL CAUSE SERIOUS RESULT OF BODY INJURY AND FORTUNE DAMAGE, EVEN DEAD.
   Check leakage, turn the knob to ” off ” position, put soap water on connectors of gas hose, then open the gas valve, bubbles indicate leakage if found. You need to check the gas connection again then re-check the leakage.

WARNING: LEAKAGE MUST BE CHECKED AT THE FIRST USE, NEVER USE THE STOVE WITHOUT LEAKAGE CHECK.

8. The distance between the products be put around and stove should be more than 15cm, there should be more than 100cm space above the stove.

9. The distance between stove and cylinder should be around 1 m, the proper length of inlet gas hose is 1 m-2m. One side of the hose connect the cylinder, the other side connect the gas inlet hole of stove, the hose can not contact the stove and thrill through the bottom of the stove, can not bend it forcedly.

10. Both left and right burner of the stove can be used to heat convex bottom utensils or pans (cookers),proper diameter of convex bottom utensil is 32cm, proper diameter of pan is between 26-30cm,the weight of food should less than 10kg; For 3 burner stove, proper diameter of pan is between 9-12cm for the mid burner, and the weight of food should be less than 1kg, the cooker should be put even not deflected.
    
    It is recommended installing range hood above the stove, and the distance between top of the stove to bottom of range hood is about 700mm.

OPERATION STEPS AND ADJUSTMENT

1. Make sure all knobs on the “off” position, then open the main gas valve.

2. Press the knob down by 3mm as the follow drawing shows, then turner it counter-clockwise until you hear ignition click, ignite the burner, then release the knob. (It may fail to ignite at the first time because of there is air in the hose, you have to repeat this procedure)

3. Adjustment: the flame can be adjusted by turn the knobs slowly.( As drawing 3 shows)
   

4. Damper adjustment: the normal and good performance flame should be blue with very small yellow flame at the flame tip. If you find the flame is too much yellow, you can adjust the valve damper to get the desired flame
   
   
   WARNING
   THE DAMPER HAS BEEN SET BY THE PRODUCER, IT IS NOT RECOMMEND THE USER TO ADJUST IT BY THEMSELVES. ASK QUALIFIED TECHNICIAN OR INSTALLER TO ADJUST THE DAMPER IF WARNING IT IS REALLY NECESSARY.

5. Flame out: turn the knobs clockwise to “off” position as drawing 3 shows, the flame will be extinguished, then close the main gas valve.

CLEAN AND MAINTENANCE

1. Surface, trivet and mid burner cap of ETG735GK maintenance: wipe the glass surface & trivet by dishcloth, which with medium scour, then dry thoroughly with a dry cloth.
   

2. Burner cap maintenance: in order to keep good burning condition, it is better to clean the burner cap weekly. For left and right burner cap of ETG725GK & ETG735GK, take off the burner cap by hands or nipper plier, clean it by scouring pad with medium scour, then wash by clean water, and dry naturally, then put it back to burner.
   

For left and right burner cap of ETG724GK, clean the burner cap by the steel clean plate.

TROUBLESHOOTING

times
Put the saucer in wrong position| Correct the saucer position
Abnormal flame| Red flame| Air humidity and smoke is too big| ordinary phenomenal
Yellow flame| Some feculence in the hole of burner cap| Clean the burner cap
The gas in the cylinder is going out| Change the cylinder
Backfire| Pressure is too low| Check whether there is gas in the cylinder and the valve has been opened or damaged
Something overflow the hole of burner cap or there is feculence| Clean the burner cap
Time of burning is too long| Paused and use again after cooling
flame short| Gas pressure is too low| Check whether there is gas in the cylinder and the valve has been opened or damaged

CUSTOMER CARE CENTER

Thailand
Call Center Tel : (+66 2) 725 9000
Electrolux Thailand Co.,Ltd.
Electrolux Building 14th Floor 1910 New Petchburi Road, Bangkapi,Huay Kwang, Bangkok 10310
Office Tel : (+66 2) 7259100
Office Fax : (+66 2) 7259299
Email : customercarethai@electrolux.com

Indonesia
Hotline service: 08041119999
PT. Electrolux Indonesia
Electrolux Building
JI.Abdul Muis No.34, Petojo Selatan, Gambir Jakarta Pusat 10160
Email: customercare@electrolux.co.id
SMS & WA : 0812.8088.8863

Vietnam
Domestic Toll Free : 1800-58-88-99
Tel : (+84 8) 3910 5465
Electrolux Vietnam Ltd.
Floor 9th, A&B Tower
76 Le Lai street – Ben Thanh Ward – District 1 Ho Chi Minh City , Vietnam
Office Tel : (+84 8) 3910 5465
Office Fax : (+84 8) 3910 5470
Email : vncare@electrolux.com

Hongkong
Tel: (+852) 8203 0298
Dah Chong Hong, Ltd. – Service Centre 8/F., Yee Lim Godown Block C 2-28 Kwai Lok Street, Kwai Chung, N.T.
Hong Kong

Malaysia
Domestic Toll Free : 1300-88-11-22
Electrolux Home Appliances Sdn. Bhd.
Unit T2-7, 7th Floor, Tower 2 , Jaya33 Hyperoffice, No. 3, Jalan Semangat, Seksyen 13, 46100 Petaling Jaya, Selangor
Office Tel : (+60 3) 7843 5999
Office Fax : (+60 3) 7955 5511
Email : malaysia.customercare@electrolux.com

Philippines
Domestic Toll Free : 1-800-10-845-care 2273
Customer Care Hotline : (+63 2) 845 care 2273
Electrolux Phils Inc.
25th Floor, Equitable Bank Tower 8751 Paseo De Roxas, Makati City,
1226 Philippines
Office Tel : (+63 2) 845 4510
Office TeleFax : (+63 2) 845 4543
Office Fax : (+63 2) 845 4548
Email : wecare@electrolux.com

Singapore
CUSTOMER CARE HOTLINE : (+65) 6507 8699
Electrolux S.E.A. Pte Ltd.
11 Lorong 3 Toa Payoh
Jackson Square, Block B, #01-13/14/15
Singapore 319579
Office Tel : (+65) 6507 8900
Office Fax : (+65) 6356 5489
Email : customer-care.sin@electrolux.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>