WOODCESSORIES ECO610 3-in-1 Wireless Ladestation 30w User Guide
- June 5, 2024
- WOODCESSORIES
Table of Contents
WOODCESSORIES ECO610 3-in-1 Wireless Ladestation 30w
INSTRUCTION
- Connect your charger and USB-C cable to a power socket. Needed: For stable charging connect the USB-C cable to a 30W (or higher) power adapte Once the Wireless Charger is connected to power the LED lights will flash for 2 seconds.
- Place the Charging Pad on a flat surface like your desk.
- Place your Qi-enabled smartphones on the left and right wireless coil of the charger. Especially for i Phone MagSafe models or cases with built-in magnets it is important to place the smartphones on the correct position. Place your Apple Airpods on the coil in the middle of the Charging Pad.
- Your smartphone and AirPods will start charging a second after you place ít on your charger. The LED lights will stay on to showcase the charging process
THINGS TO WATCH
- If your phone vibrates your phone might shift position.
- If this happens often, consider turning off vibration mode.
- Your phone might get slightly warmer while it charges.
- This is totally normal. You might consider moving the charger to a cooler place.
Important
Your phone or phone case cannot carry any metal materials, which will stop the charging process, such as rings, keys, or metal plates. If the LED starts to flash the
FOD
(foreign object detection) noticed an object which is disturbing the charging process. Please take off your devices and wait for 10 seconds to re-start the charging process you noticed flashing LED lights a problem might have occurred. In this case, take off your devices and re-connect the charger with your power source. Make sure that the power source is high enough to support the Charging Pad.
RECOMMENDATION
FCC CERTTFIED
This device complies with part 15 of the FCC Rules Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
FC Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rubs These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
FCC INFORMATION
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: –
- Reorient or relocate the receiving antenna,
- Increase the separation between the equipment and recover.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced technician To maintain compliance with
FCC’s RF exposure guidelines
This equipment should be installed and operated with a minimum distance between 20cm the radiator your body: Use only the supplied antenna
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>