WOODCESSORIES ECO606 Fast Single Charger User Guide
- June 5, 2024
- WOODCESSORIES
Table of Contents
WOODCESSORIES®
THANKS FOR CHOOSING
WOODCESSORIES!
CHARGE SMART.
CHARGE SUSTAINABLE!
WOODCESSORIES®
NATURE
MEEETS TECH!
BE FLEXIBLE.
CHARGE ALL YOUR QI DEVICES!
- For 15W fast charging output, use 20W QC/PD Adapter or higher!
- Specs: Output: 7.5/10/15W, Charging Distance: 0-5mm
INSTRUCTION
- Connect your charger to power. Use the USB-C cable and connect with a power socket or laptop. Highly recommended: Connect the USB-C cable to a 20W (or higher) power adapter. Once the charger is connected to power the LED light will flash for 3 seconds.
- Place the Single Charging Pad on a flat surface like your desk.
- Place your wireless charging enabled phone in the centre of the charger. Especially for iPhone MagSafe models or cases with build-in magnets.
- Your smartphone should start charging a second after you place it on your charger. The LED light will stay on to showcase the charging process.
- An additional, free adapter gives you the ability to switch from USB-C to USB-A ports
RECOMMENDATION
NOTE: Connect the USB-C cable to a 20W (or higher) power adapter to enjoy 15W fast charging
THINGS TO WATCH
- If your phone vibrates your phone might shift position. If this happens often, consider turning off vibration mode.
- Your phone might get slightly warmer while it charges. This is totally normal. You might consider moving the charger to a cooler place.
- Important: Your phone or phone case cannot carry any metal materials, which will stop the charging process, such as rings, keys, metal plates. If the LED starts to blink the FOD (foreign object detection) noticed a problem. Please re-connect your charger with power if this happens.
ENJOY FAST & SUSTAINABLE CHARGING!
CHARGING GUIDE
Need help?
Get in touch!
hello@woodcessories.com
Please read the instruction carefully before using the Wireless Charger!
FCC CERTIFIED
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment. NOTE:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
FCC INFORMATION
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced technician
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with minimum distance between 20cm the radiator your body: Use only the supplied antenna.
Need help?
Get in touch!
hello@woodcessories.com
Documents / Resources
|
WOODCESSORIES ECO606 Fast Single
Charger
[pdf] User Guide
ECO606, 2A36GECO606, ECO606 Fast Single Charger, Fast Single Charger
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>