Guangzhou Zinta Trade ZT-RCS-2 Remote Control Switch Instructions
- June 5, 2024
- Guangzhou Zinta Trade
Table of Contents
Zinta Trade ZT-RCS-2 Remote Control Switch
Instructions
ZT-RCS-2 Instruction
@Operation Mode Option:
A: Automatic Operation
- Jumper K1 on the PCB unconnected
- Press “UP” one time, the motor goes up, Blue & Yellow wires output; press “UP” a second time, and the motor stops working
- Press “DN” one time, the motor coming down, White & Green wires output; press “DN” second time; the motor stop working
- If press “DN” while the motor going up, then the motor will come down immediately
- If press “UP” while the motor coming down, then the motor will go up immediately
B: Manual Operation:
- Jumper K1 on the PCB connected
- Pressing and holding the “UP”, Blue & Yellow wires output, the motor going up; release the button “UP”, the motor stop working
- Pressing and holding the “DN”, White & Green wires output, the motor coming down, release the button”DN” , the motor stop working
@New Remotes Programming:
- Open the controller box, pressing on the button on the PCB, and the LED lighting
- Pressing on any button of the remote till the LED turn off
- Remote program success
- 4 remotes are available at most
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>