schuller 748261 2100W Heat Vulcan Floor Heater Instruction Manual

June 5, 2024
Schuller

schuller 748261 2100W Heat Vulcan Floor Heater Instruction Manual

IMPORTANT INSTRUCTIONS

  1. Only use the halogen heater on a firm solid horizontal area where all the feet on the base are in contact with the floor. (Should the heater be tilted or fall over the auto cut off switch will activate)
  2. Site the heater outside or in a large open area and well away from any obstructions such as branches or where the heater is near any objects that can effected by heat, such as furniture, curtains or other inflammable objects (minimum distance 1 meter).
  3. Do not use in unventilated areas.
  4. Do not use where gas, petrol, paint or other inflammable goods are stored.
  5. Do not push any items through, obstruct or cover the grill of the heater head.
  6. Do not leave turned on and unattended especially when children and or animals are in the vicinity.
  7. The indication of the different positions of switches shall be visible from a distance of 1M.
  8. The Marking concerning covering shall be visible after the heater has been installed. It shall not be placed on the back of portable heaters.
  9. The unit must be securely placed on a horizontal and flat surface.
  10. The unit is at high temperature during operation. It keeps hot for a period after shut down. Potential danger would occur when touching it during this period.
  11. Don’t place the unit closed to curtain and/or other flammable objects. Otherwise there will be a danger of catching fire.
  12. Don’t cover the unit with anything during operation or a short time after it’s shut down.
  13. Don’t wrap the power supply cord on the unit.
  14. The unit must be handled with care, and avoid vibration or hitting.
  15. The unit must be securely grounded during operation.
  16. When assembling, keep clear from any board or flammable material.
  17. The head of the unit is at high temperature during operation.
  18. Unplug the unit and wait till it cools before cleaning.
  19. Don’t use this unit in place where causticity or volatile air exists, i.e. dust, steam, gas, etc.
  20. Don’t use this unit as a cloth drier or towel drier.
  21. Don’t use this unit as a sauna heater.
  22. Don’t use this unit in place of animal propagating and raising.
  23.  Don’t immerse this unit into water for cleaning.
  24. The unit should be plugged in a socket, which is easily visible and reachable.
  25. Two Dark points may exist on the surface of the heating elementsduring the first few minutes after it is turned on. This is normal, and will not affect the performance of the unit.
  26. Children of less than 3 years should be kept away unless continuously supervised.
  27. Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its intended normal operating position and they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance.
  28. CAUTION — Some parts of this product can become very hot and cause burns.
  29. Particular attention has to be given where children and vulnerable people are present.

Assembling Process

Step 1: Connect the bottom tube with base by screwing them together.

Step 2: Screw the middle tube with the bottom tube.

Step 3: Feed the Power Cord through the Base and the Bottom Tube, middle tube ,and pull through around 2m of cable.

Step 4: Place the power cord plug through base, bottom pole, middle Pole and top pole. Connect the power cord plug to the socket in the heater head.

Step 5 Push the heater head onto the top hollow tube and fix it in position using the supplied 2 X M4*8 screws

Step 6: Pull the power cord gently out of the base as much as possible. Fix the power cord under the weighted base using the supplied 4pcs M4 nuts.

Step 7: Raise or retract the top telescopic tube to the deOred height and tighten to the middle tube by screwing knob down

Completel

OPERATING INSTRUCTIONS

Connect the power cable to a 13 amp supply that is located in a safe, dry area. WARNING: The heater must be properly installed before it is used .This unit is equipped with one heat setting On / Off.

  • Plug the Patio Heater into a grounded 220V-240V,50-60Hz power outlet
  • Only operate the heater when it is in the upright position.
  • Our Electric Patio Heater is equipped with Three heat settings power of the heater.
  • Press on the OIVOff switch to activate the heater A. To operate the heater on low power (900W), press on the left side button of the remote control B. To operate the heater on high (1200W), press on the right side button of the remote control C. Press on both the left and right side button of the remote control for maximum power (2100W)

Touch Switch

A. Press on the button once to operate the heater on low (900W) power.
B. Press on the button twice to operate the heater on high (1200W) power.
C. Press on the button third times to operate the heater on (2100W) polvver.
D. Press on the button four times to shut the light and heat off.

  • Although the patio heater is shower proof, do not use when raining or in wet conditions.
  • Always disconnect the power cable from the electrical supply, when the patio heater is not in use.

Technical specification

Voltage Rating 220-240V, 50Hz
Power Consumption 900W/1200W/2100W
Unit Size 58.5cm (W)×46cm(D)×160-205cm(H)
Unit Weight 13.7kg

MAINTENANCE

Unplug the unit and let it cool completely.

  • To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. You may use a mild detergent if necessary. After cleaning, dry the unit with a soft cloth.
  • DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to clean the heater. This may cause damage or deterioration to the surface of the heater.
  • Although this heater is outdoor approved, DO NOT immerse the heater in water for your safety.
    Wait until the unit is completely dry before use.

STORAGE

If the heater will not be used for a long period of time, store it in a cool, dry location when not in use. To prevent dust and dirt build-up, use the original packaging to repack the unit.

WEEE

This product contains recyclable materials. Do not dispose this product as unsorted municipal waste. Please contact your local municipality for the nearest collection point.

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Related Manuals