Konnect RC463A Hub User Guide
- June 5, 2024
- Konnect
Table of Contents
Konnect RC463A Hub
OVERVIEW
-
REAR
-
IN-THE
- FRONT/SIDE
ARRIS and the ARRIS Logo are trademarks of CommScope, Inc. and/or its
affiliates. All other trademarks are the property of their respective owners.
No part of this content may be reproduced in any form or by any means or used
to make any derivative work (such as translation, transformation, or
adaptation) without written permission from CommScope, Inc. and/or its
affiliates (“CommScope”). CommScope reserves the right to revise or change
this content from time to time without obligation on the part of CommScope to
provide notification of such revision or change.
CommScope provides this content without warranty of any kind, implied or
expressed, including, but not limited to, the implied warranties of
merchantability and fitness for a particular purpose. CommScope may make
improvements or changes in the products or services described in this content
at any time. The capabilities, system requirements and/or compatibility with
third-party products described herein are subject to change without notice.
The terms HDMI, HDMI High-Definition Multimedia Interface, and the HDMI Logo
are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.
Manufactured under license from Dolby Laboratories.
Kayden is registered with Companies House as Kayden Limited
Open Source Soft are Information
For instructions on how to obtain a copy of any source code being made
publicly available by ARRIS related to software used in this ARRIS prod- uct
you may send your request in writing to: ARRIS, Software Pedigree Operations,
2450 Walsh Avenue, Santa Clara, CA 95051, USA
The ARRIS website opensource.arrisi.com also contains information regarding
use of open source. ARRIS has created the opensource.arris.com site to serve
as a portal for interaction with the software community-at-large.
An ARRIS product, do not dispose of the product with residential or commercial
waste. Some countries or regions have set up systems to collect and recycle
electrical and electronic waste items.
Recycling information can be obtained from the WEEE recycling section at
www.commscope.com.
Please recycle product packaging and this document. ARRIS, 71 Lakefield Drive,
Suwanee, A 0024, USA www.commscope.com
CARING FOR THE ENVIRONMENT FOR THE RECYCLING
Ambient operating temperature| 2-104°F / 0-40°C at 5-95% non condensing
humidity.
---|---
Voltage| 12Vdc, 1.67A
Power supply unit| This Class III product, HC200 , shall be powered by the
Power Supply that is provided together with the product.
Power consumption| 20W
-
Connect one end of the HDMI cable to your Hub To TV port and the other end to the HDMI connector on to your TV set.
-
( Optional ) If you have a set-top box, then connect one end of the HDMI cable to your Hub I PUT port and the other end to your HDMI connector on to your set-top box.
-
Optional – if you prefer a wired connection) Connect one end of the Ethernet cable to your Hub Ethernet port and the other end to your home router.
-
Connect one end of the US – C type cable to one end of the power supply and the other end to your Hub US port
Connect the power supply to the power
NOTE : Do not use any power supply other than the one supplied with the product. Doing so may cause fire or seriously damage your Hub.
Mounting your Hub
You can mount your Hub on top of your TV as shown below or you can mount on a table-top with the neck folded.
Note : Do not try to slide the shutter cover manually as it automatically
slides open for a video call and slides back in as the call ends
For more information about configuring your Hub and setting up Wi-Fi
connection.
IMPORTANT SAFETY INSTRUCTIOS
Never place the product on top of or close to any heat sources such as other electronic devices. Doing so will reduce life time and may cause irreparable damage or malfunction. Do not use the product near water. Note that the ambient temperature must be below 104° F/40°
- Be sure to maintain necessary space around the product to allow for proper ventilation. Never use the product outside. Do not use any power supply other than the one supplied with the product. Doing so may cause fire or seriously damage the product.
CANADIAN COMPLIANCE:
This Class digital apparatus meets all requirements of the Canadian
Interference Causing Equipment Regulations and CAN ICES-00 ( )/ NM -00 ( ).
This device complies with Innovation, Science and Economic Development
Canada’s license-exempt RSSs. Operation is subject to the following two
conditions:
- This device may not cause interference and
- This device must accept any interference, including interference that may cause undesired operation of the device.
CAUTION: The device for operation in the band 5150 5250 MH is only for indoor use to reduce the potential for harmful interference to co- channel mobile satellite
RADIATION EXPOSURE STATEMENT
This equipment complies with Canada radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body.
FEDERAL COMMUNICATION COMMISION INTERFERENCE STATEMENT:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following
measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC CAUTION
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this
equipment. This transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter.
RADIATION EXPOSURE STATEMENT
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body.
EUROPE UNION (EU) COMPLIANCE AND MANUFACTURER CONTACT ADDRESS
EU Compliance is maintained at the following address: ARRIS Group .V.,
Hoogoorddreef 5, 1101 A Amsterdam- Zuidoost, The Netherlands
UNITED KINREGDOM COMPLIANCE AND MANUFACTURE CONTACT ADDRESS
UK Compliance is maintained at the following address: ARRIS Global Limited,
Victoria Road, Saltaire, West Yorkshire, D1 LF, United Kingdom
ARRIS declares that this product is in compliance with Directive 2014/5 /EU.
The full test of the EU declaration of conformity is available at the
following Internet address:
http://arris.com/consumers/eudoc.
Disabling Wireless
- This equipment is dependent on wireless for primary operation.
- To disable wireless disconnect the product from power.
- The following table shows the RF Output Power for CPE wireless devices:
Frequency Band ( MHz )
|
M aximum RF Power (dBm)
---|---
2410 to 2480
|
20
| Frequency Band ( MHz ) | M ean e.i.r.p limit for Ph (dBm) |
|---|---|
| Without TPC |
5150 to 5 50
| 2| 20/2
5470 to 5725| 0|
27
Indoor use only BE, CZ , DK, DE, EE, IE, EL, ES, FR, HR, IT, C , LV, LT, LU,
HU, MT, NL, AT, PL, PT, RO, SI, SK, FI, SE UK(NI).
Note 1: The applicable limit is 20d m, except for transmissions whose
nominal bandwidth falls completely within the band 5150 to 5250 MH , in which
case the applicable limit is 2 d m.
Note 2: The applicable limit is 7d m, except for transmissions whose
nominal bandwidth falls completely within the band 5150 to 5250 MH , in which
case the applicable limit is 10 d m/MH . Note : Slave devices without a Radar
interference Detection function shall comply with the limits for the frequency
range 5250 MH to 5 50 MH .
Energy Consumption The following energy consumption figures apply with all interfaces active and in an idle state (measured with a wattmeter at the outlet):
State|
Power consumption
---|---
OFF
| 20 Watts
ON|
20 Watts
EU External Power Supply
In accordance with Commission Regulation (EU) 2019/17 2, energy efficiency
data for the power supply provided with this product is available here:
https://
www.commscope.com/consumers/psuinfo.
Mounting Instruction
If you prefer to mount your Hub, then use a 1/4-20 UNC thread screw for
mounting the hole on the stand.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>