LDZER ISUZU DMAX 2017+ Grille Mounting Kit for Linear 6 Instruction Manual
- June 3, 2024
- LDZER
Table of Contents
ISUZU DMAX 2017+
FITTING INSTRUCTIONS
GRILLE MOUNTING KIT FOR LINEAR-6
TECHNICAL SUPPORT
aaron@lazerlamps.com /
sales@lazerlamps.com
+44 (0)1992 945601 / +44 (0)1992 677374
WHAT’S REQUIRED
- 2x LINEAR-6 LIGHTS
- 1x TWO LAMP HARNESS KIT
- 1x ISUZU DMAX 2021, LINEAR-6 MOUNTING KIT
DIFFICULTY LEVEL
TOOLS REQUIRED
PRE-INSTALLATION CHECKS
1. Ensure the battery is disconnected.
INSTALL PROCESS
STEP 1
Remove the 10 plastic retaining rivets that hold the slam panel cover in
place. 
STEP 2
Remove the slam panel cover and set it to one side.
STEP 3
Assemble Lamps to the ‘U-shaped bracket as shown using the supplied
fixings.
STEP 4
Fix the outboard side brackets to the Lamps.
STEP 5
Carefully insert the lamp assembly into position behind the center
grille.
STEP 6
The center bracket should sit on top of the metal support located below the bonnet catch.
Mark the drill locations.
STEP 7
Drill x2 6mm holes and secure the center bracket to the metal support with the
included fasteners.
STEP 8
Mark out where the end brackets need to be drilled and drill a 6mm hole.
STEP 9
Place the included 5mm spacer between the bracket and the grille to level the
lamp and secure it with included fasteners.
STEP 10
Aim lights, check functionality, and tighten, them before re-assembling the
vehicle.
Thank you for choosing a Lazer Lamps product.
Lazer Lamps Ltd
Units 1-2 Harlow Mill Business Centre
Riverway Harlow CM20 2FD
UK | +44 (0) 1992 677374www.lazerlamps.com