Apulsetech A411 Desktop Reader User Manual

: June 5, 2024
: Apulsetech

Table of Contents

Device pictures and switches, LED Description
Driver installation notification mode
Read User Manual Online (PDF format)
Download This Manual (PDF format)

A411 Desktop Reader
User Manual

Device pictures and switches, LED Description

– HID MOD

Status light LED: RED
On/Off Switch And LED: Green
MOD Changeover Switch: H(HID)

– Serial MOD

StatuslightLED : Green(Flickering)
On/Off Switch AndLED: Green
MOD Changeover: S(Serial)

Driver installation notification mode

Status light LED: RED(Flickering)
On/Off Switch And LED: Green
MOD Changeover: H(HID)
PC notifies when the mode switch is S
Order of using HID MOD
1-1. Set the mode select switch to H (HID).
1-2. Install driver on PC (ex) AT9S_driver_xXX)
1-3. After connecting the USB cable to the PC, press the On / Off switch to turn on the power.
1-4. Open the document file (Txt, Docx, Xlsx, etc.) to display the tag information. 1-5. Start tag reading.
Order for using Serial mode
2-1. Set the mode select switch to S (Serial)
2-2. After connecting the USB cable to the PC, press the On / Off switch to turn on the power.
2-3. When the PC catches the port, it opens and controls related programs and tools.

This product is mounted out of reach of Users.

FCC Information to User
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

this device may not cause harmful interference, and
this device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.

IMPORTANT NOTE:
FCC RF Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.