ALCOVISOR V6 AlcoTorch Rapid Fuel Cell Baton Alcohol Breathalyzer User Manual
- June 5, 2024
- ALCOVISOR
Table of Contents
ALCOVISOR V6 AlcoTorch Rapid Fuel Cell Baton Alcohol Breathalyzer
This alcohol analyzer is only used to make a rapid, non-contact detection based on Ethyl Alcohol from the drivers, and features a powerful flashlight and baton.
STRUCTURE
DETAILED PROCEDURE
Alcohol Analyzer
- Press and hold the “On/Off Button” for 2 seconds to switch on the device.
- The display shows “Ready”.
- Auto Test: Put the device in the front of the testee’s mouth and nose and blow for 2-4 seconds. The device will test the airflow and do sampling automatically. The test result is displayed after the test.
- Passive Test: Press the “On/Off Button” to make a passive test. The device will take air samples continuously for a few seconds, move the device around the nose and the mouth of the testee during sampling. The test result is displayed after sampling.
- Press the “On/Off Button” for another test
- When displays “Ready”, press and hold the “On/Off Button” for 3 seconds to turn off the device. The device will be automatically turned off after 5 minutes.
Flashlight
Press ” Flashlight Button” to switch the flash frequencies between steady,
flashing, and off.
Torch
Press “Torch Button” to switch the Torch lights between front, bottom, front &
botton and off.
Menu
When displays “Ready”, press and hold the “Flashlight Button” for 3 seconds to
enter the Menu. Select the items by using the three buttons.
- Records: Displays test records, 8000 test rerecords can be saved.
- Device Info: To check the serial number, software version and last calibration date of the device.
- Calibration: Refer to Calibration Instruction. The calibration option is protected by passwords and can only be operated by a trained operator.
- Setting: Refer to Setting Instruction. The setting is protected by passwords and can only be operated by a trained operator
- Date & Time Set the date and time.
- Auto-Off Select whether the device is auto-off. The default setting is auto-off on, the device will be switched off after 5 minutes
- Flash Select whether the flashlight is on when the test result is above Alarm level. The default setting is on. The current date and time are displayed on the bottom of the menu screen.
Charging the device
Connect the USB cable and charge the device, a red light will be turned on
when charging. The red light will be turned off when the battery is fully
charged. Charging time is about 3-4 hours.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>