Sewell SW-32988 BlastIR Wireless Pro IR Repeater User Manual
- June 5, 2024
- Sewell
Table of Contents
Sewell SW-32988 BlastIR Wireless Pro IR Repeater
**Setup: Step One
**
Connect each unit to power using either the included power supplies or the USB to DC cables. It is easy to mistake the IR cable port on the front for the power port Please ensure that the power adapter is plugged into the appropriate port at the back.
Setup: Step Two
Place the blue unit next to your display.
Setup: Step Three
Place the orange unit in front ot the device that you wish to control. Ensure that the IR emitter has a clear line of sight to the IR “eye” of your device.
Optional IR Cables
The IR Emitters transmit from the adhesive side of the head and should be
adhered directly over the location where your device receives its IR signal.
(Location Varies)
If you want to extend the reach or hide the receiver or emitter, connect the appropriate color-coded cable to the device. The blue IR receiver cable will add another receiver you can point your remote at. The orange IR emitter cable can attach to the IR “eye” of the device you wish to control.
Optional Adhesive Placement
lo keep the BlastlR Wireless in one place, we have included Airstick and 3MH adhesive. Airsick” is used as pictured above and it is designed to be reusable and leave no residue. The 3M adhesive is used the same way and is used for more permanent placement.
Optional Magnetic Placement
To keep the Blast IR Wireless in one place, we have included blue Rubber Magnetic Feet that you can stick to the bottom of each device to secure your device on any metal surface. Note: The magnet will not harm nor disrupt the functionality of the device.
Multizone
BlastlR Wireless receivers will only communicate with the emitters that are set to the same zone. The extender supports up to ten unique zones of communication. Setting the receiver’s zone to “0” will allow communication to previous models of the BlastIR Wireless.
Possible Setups
Port Diagram
Troubleshooting
- The blaster Wireless Pro transmission range can be reduced by walls or other objects between the receiver and emitter as well as by other wireless signals in the same area. If you are having trouble with the emitter receiving the signal we recommend testing it with the receiver and emitter in the same room in order to verify that nothing is interfering with the signal.
- If the emitter or receiver seems to be cutting in and out, then the power connector may not be properly seated. We recommend reseating in the power connector. Keeping the modules in a place where there is minimal vibration or another movement will help prevent the power connectors from coming loose.
- Make sure that the receiver and emitter are set to the same desired channel before use. If they are on a different channel, then the emitter will not recognize the signal from the receiver.
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>