Arches L5B83G Bluetooth Device User Manual
- June 5, 2024
- Arches
Table of Contents
Arches L5B83G Bluetooth Device
Introduction
This product is a Bluetooth Low Energy technology enabled Remote Control for use with a paired Media Player.
- Operating Frequency Range: 2402 – 2480 MHz
- Maximum Effective Isotropic Radiated Power (EIRP) : 10dBm
WHAT’S IN THE BOX
- Marketing Name: Wireless Remote, Model L5B83G
- 2xAAA Batteries
Setting up the device
- Insert the batteries and install the compartment cover
- Pair the device with the host. Choose the applicable pairing instructions from options A or B below:
- This is a replacement remote control:
- Restart your Media Player / TV USB Stick by disconnection from and then reconnection to the AC power. After the TV home screen displays your new remote it is ready for pairing.
- Press and hold the Home button on the new remote for at least 10 seconds. The new remote should automatically pair with your TV USB stick. You will see an on-screen message when it has successfully paired.
- This is an additional remote control:
- On your new remote, press and hold the Home button for 120 seconds to enter discoverable mode.
- You must use your existing remote for the following steps.
- Press the Home button.
- Navigate to the Settings location at the top of the Media Player TV screen. Select Controllers and Bluetooth Devices > TV Remotes > Add New Remote. The Media Player application will search for discoverable remotes and display them in a list.
- Select the new remote. You will see an on-screen message when it has been successfully paired.
Use your Voice Search
- Hold down voice search button and speak
Safety and Compliance Information
For safety, compliance, recycling, and other important information regarding your Device, please refer to the Legal & Compliance section in the User Manual.
Caution: risk of explosion if the batteries are replaced by an incorrect type. Dispose of used batteries according to the instructions.
Using Your Device Around Other Electronic Devices
- The Device, uses, and can radiate radio frequency (RF) energy and, if not used in accordance with its instructions, may cause interference to radio communications and electronic equipment. External RF signals may affect improperly installed or inadequately shielded electronic operating systems, entertainment systems, and personal medical devices.
- While most modern electronic equipment is shielded from external RF signals, if in doubt, check with the manufacturer. For personal medical devices (such as pacemakers and hearing aids), consult with your physician or the manufacturer to determine if they are adequately shielded from external RF signals.
- There are some places where RF signals could constitute a hazard, such as health care facilities, and construction sites. If you are not sure, look around for signs indicating that two-way radios or mobile phones should be turned off.
FCC – regulatory user information
This equipment complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference
- This device must accept any interference received, including interference that may cause undesired operation.
Modifications of the equipment which are not expressly approved by the party responsible for it’s compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected. -
Consult the dealer or an experienced radio/TV technician for help.
Innovation, Science and Economic Development Canada (ISED) – regulatory user information
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference; and
- This device must accept any interference, including interference that may cause undesired operation of the device.
EU Declaration of Conformity:
Hereby, Amazon.com Services LLC., declares that the radio equipment type L5B83G is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.amazon.com/device_eu_compliance.
Brazil Compliance Warning Statement
Documents / Resources
|
Arches L5B83G Bluetooth
Device
[pdf] User Manual
L5B83G Bluetooth Device, Bluetooth Device
---|---