LiftMaster PPLV1 Passport Lite Remote Control User Manual

June 5, 2024
LiftMaster

PASSPORT
User Manual

Model PPLV1
**| Models PPLK1 and PPLK1PH**

---|---

NOTE: The images are for reference and your product may look different.

INTRODUCTION

The Passport LITE is a credentialed remote control. The Passport LITE remote control is a versatile remote control that can be used on access control systems, commercial door operators, gate operators, and external receivers (Models PPWR, 850LM, 860LM, STAR1000) that use Security**+**2. OTM technology.
NOTE: PassportLITE credentialed remote controls are not compatible with CPWR, CPWR3, RFMODKT, and RFMODKT3 Passport products.

PROGRAMMING

Depending on your product, the LEARN button or LCD menu will be used to program the remote control.
If programming to an access control system or gated entry, contact your property manager or LiftMaster® dealer for assistance with any programming or operating instructions.
NOTE: Passport Lite remote controls are NOT compatible with residential garage door openers.

  1. Locate the LEARN button on your product or the PROGRAM button on the LCD (if applicable).
    WARNING
    To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door:
    • ALWAYS keep remote controls out of reach of children. NEVER permit children to operate, or play with remote controls.
    • Activate gate or door ONLY when it can be seen clearly, is properly adjusted, and there are no obstructions to door travel.
    • ALWAYS keep the gate or garage door in sight until completely closed. NEVER permit anyone to cross the path of a moving gate or door.
    WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer or birth defects, or other reproductive harm. For more information go to www.P65Warnings.ca.gov

  2. Press and release the yellow LEARN button on your product or the PROGRAM button on the LCD. NOTE: The button color on commercial products may vary.

  3. Press and hold the remote control button you wish to use until your product’s programming LED turns off

  4. To test, press the programmed button on the remote control and the product will activate.

Please refer to your access control system owner’s manual for instructions on programming the PassportLITE credentialed remote controls.

HOW TO USE THE REMOTE CONTROL

Press and hold the button down until the door or gate starts to move. For key chain, and remote controls with a proximity sensor, hold the remote control 1-2′ away from the reader’s face and wait for a confirmation beep or LED from the reader. The operation of the proximity sensor varies depending on the access control system. For additional information refer to the owner’s manual for the access control system.

THE REMOTE CONTROL BATTERY

To replace the battery, open the case as shown. Insert battery positive sic up (+). Replace the battery with only a 3V CR2032 coin cell battery. Dispose of the old battery properly.

VISOR REMOTE
Pry open the case first in the middle (1), then at each side (2 and 3) with the visor clip.| KEY CHAIN REMOTE
Pry open the case with a screwdriver blade.
---|---
|

WARNING
To prevent possible SERIOUS INJURY or DEATH:

  • NEVER allow small children near batteries.
  • If the battery is swallowed, immediately notify the doctor. To reduce the risk of fire, explosion, or chemical burn:
  • Replace ONLY with 3V CR2032 coin batteries.
  • DO NOT recharge, disassemble, heat above 212° F (100° C), or incinerate.

NOTICE: This device complies with part 15 of the FCC rules and Innovation. Science and Economic Development Canada license-exempt RSS. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device must be installed to ensure a distance of 55 mm is maintained between users/bystanders and the device.

REPLACEMENT PARTS
3V CR203Lithium battery …………………….10A20
Visor Clip……………………………………………….. 296137

ONE-YEAR LIMITED WARRANTY
The Chamberlain Group, Inc. warrants to the first consumer purchaser of this product that it is free from defects in materials and/or workmanship for a period of 1 year from the date of purchase.

114A4494C
© 2014, The Chamberlain Group, Inc.
All Rights Reserved
1-800-528-9131
WWW.littmaster.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

LiftMaster User Manuals

Related Manuals