Kangtai 90047 Wireless Door Chime User Guide

: June 5, 2024
: Kangtai

Table of Contents

Kangtai 90047 Wireless Door Chime
Pairing
Melody Selection
Mount Devices
Clear Memory
Troubleshooting
Technical Data
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Kangtai 90047 Wireless Door Chime

Kangtai-90047-Wireles-Doo-Chime-PRODUCT

Pairing

Insert the power plug of the receiver in the main socket.
Push the button on the transmitter within 2 mins
As soon as a ‘Dingbong” is heard, and pairing is complete.
Volume Levels
volume high
volume medium
volume low
no sound but with flash

Melody Selection

38 melodies door chimes when the door opens and a wide volume range of 0-115dB. Ranging from traditional doorbell chimes to jingles known around the world, the playlist certainly offers a chime that suits your taste.

Convenient nameplate in the transmitter. You can write any text content about the wireless doorbell and easy to replace the nameplate.

Mount Devices

Note
The assembly of the transmitter on metallic surface eg. metal door frames) may reduce transmitter power.

Clear Memory

Just press the melody button of the receiver for more than 6 seconds and release it.

Cleaning
NOTICE! Risk of product damage!
Never submerge the device in the water while cleaning.

Clean the outside of the device with a slightly damp cloth.
Do not use cleaning agents or solvents.

Note

Range Guide

Chime unit for INDOOR uses only.

Troubleshooting

The doorbell only works at a short distance:

Avoid placing the doorbell or bell push on metallic surfaces.
Move the doorbell to a new location.

The doorbell will not ring when the push button is pressed:

Ensure the doorbell is switched on.
Follow the “clear memory” guide to reset to the doorbell, then follow the “pairing” steps to set up the doorbell.

Caution
This device complies with Part 15 of the FCC Rules / Industry Canada licence- exempt RSS standard(). Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates use and can radiatee radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur ina particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.