Kangtai 51196USA Wireless Remote Control Socket User Guide

Kangtai 51196USA Wireless Remote Control Socket

Product Information

The product consists of a wireless remote control socket and a remote controller. The socket has various buttons and indicators, including a socket button, LED ON/OFF button, Pair Reset button, and indicator lights. The remote controller has buttons for turning on/off individual devices, all devices, and an indicator light. The product also requires a CR2032 battery for operation.

Product Specifications

• Model: 51196USA
• Working voltage: 120V~ 60Hz
• Max power rating: 1800W
• Operating range: Max 130 ft (outdoor open area)
• Frequency: 433.92MHz
• LED flash: Red
• Working temperature: 0~35°C
• Standby power consumption: 0.5W

Precautions

Please follow the safety information and precautions listed below to ensure the safe usage of the product:

• Keep button batteries away from children.
• If the battery compartment does not close tightly, stop using the product and keep it away from children.
• If you suspect a button battery has been swallowed or entered any part of the body, seek medical advice immediately.
• This device complies with Part 15 of the FCC Rules / Industry Canada license-exempt RSS standard(s).
• Any changes or modifications not approved by the responsible party may void the user’s authority to operate the equipment.

Product Usage Instructions

Battery Installation

1. Open the battery compartment and correctly install a CR2032 battery with the positive pole facing up.
2. Lock the battery cover to secure the battery in place.
3. Ensure the battery is installed correctly and remove it correctly if needed.

Pairing Setting Instructions

• Plug the socket into a power source.
• Press and hold the Pair Reset button until the indicator light starts to flash slowly.
• Follow the specific pairing steps for different devices (refer to AON pairing steps if applicable).

PRODUCT STRUCTURE

Socket

Remote controller

BATTERY INSTALLATION

PAIRING SETTING

1. Plug the socket into a power source.
2. Press and hold the button till the indicator light starts to flash slowly.
3. Press AON button of the remote controller after pairing is done, the LED indicator light is ON
   (For BON.CON.DON. pairing in sequence, please refer to the AON pairing steps)

INSTRUCTIONS

Remote control operation method

• Example: Press the AON button to turn on the device, and press the AOFF button to turn off the device.
• Example: Press the ALLON button to turn on all devices. Press the OFF button to turn off all devices.

If the remote controller is not available, the socket could be ON/OFF by pressing the button in the socket.

CLEAR RECEIVER MEMORY

Press and hold the button for around 20 seconds and release it after the indicator light turns off.

PRODUCT SPECIFICATIONS

• Model: 51196USA

• Working voltage: 120V~ 60Hz 15A

• Max power rating: 1800W

• Operating range : Max 130 ft(outdoor open area)

• Frequency: 433.92MHz

• LED flash: Red

• Working temperature: 0℃~35℃

• Use scene: Indoor

• Standby power consumption: ﹤0.5W

• Model: 50183USA

• Frequency: 433.92MHz

• Working temperature: 0℃

• ~35℃Working voltage :1x3V

• CR2032 Standby current: ﹤5μA

• Transmit power: ﹤2dBm

PRECAUTIONS

Use Information

• The following equipment must not be connected to the remote control plug:
• Equipment exceeding the technical value of the remote control plug (-> technical data).
• Equipment with motor capacitors (such as refrigerators, etc.).
• Opening the device unattended can cause fire or other damage (such as irons, etc.).
• Cathode-ray tube television.
• Do not use the remote control plug outdoors, near dripping water, and in damp rooms (bathrooms, etc.).
• In an emergency, you must have quick access to the remote control plugs so that they can be removed from the grounded contact plugs in the event of a hazard.

Safety Information

• Do not plug multiple devices into each other.
• There is no voltage when the plug is disconnected.
• Only suitable for dry rooms.
• The remote control plug can only be connected to a properly installed grounded contact socket (120V~60Hz).
• The remote control plug must not be plugged into an extension cord and must not be overloaded (maximum 1800W).
• Do not open the device. Improper assembly may cause electric shock, short circuit or fire.
• The range of the remote control plug is severely affected by structural conditions (such as reinforced concrete) or sources of electrical/electromagnetic interference (fluorescent lights, cordless phones or earphones, TV/monitors, cables, etc.). If necessary, remove disturbance sources or keep a proper distance.
• Keep the equipment installation at a distance of more than 80CM from the ground.
• Avoid humidity, extreme temperature, vibration, and shock.
• Clean with a soft, slightly damp cloth. Do not use detergents or solvents. Do not immerse in water.
• Do not plug pins or other metal objects into power outlets.
• Do not expose the battery to extreme temperatures such as direct sunlight or fire. Do not place the device on the heater. Leaking battery acid can cause damage.
• Always install batteries with the correct polarity (+ and -), as shown in the battery compartment.
• Notice! If the battery is incorrectly installed, there is a danger of explosion.
• When replacing the battery, only use the same type of battery.
• If the battery leaks, remove it from the battery compartment with a cloth, and dispose of the battery properly. If battery acid leaks, avoid contact with skin, eyes, and mucous membranes. If you come into contact with acid, immediately rinse the affected skin thoroughly with water and consult a doctor.
• Store the battery in a well-ventilated and dry place.
• If you do not use the device for a long time, remove the battery.
• Risk of explosion! Do not use other reagents to charge or reactivate the battery, and do not disassemble, throw into fire or short-circuit the battery.
• Remove the used battery from the device and dispose of it immediately.

Warning:

1. This product contains button batteries. If you swallow a button battery, it will cause severe internal hurt within 2 hours and may result in death.
2. Keep new and used batteries away from children.
3. If the battery compartment cannot be closed tightly, please stop using the product and keep it away from children.
4. If you think the battery may be swallowed or enter any part of the body, please seek medical advice immediately.

FCC

Caution:
This device complies with Part 15 of the FCC Rules / Industry Canada license- exempt RSS standard(s).
Operation is subject to the following two conditions:

1. this device may not cause harmful interference,
2. this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Wireless Remote Control Socket
User Guide: 51196USA+50183USA

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>