KINGSTATE ANC-TWS-S1 TWS Bluetooth Earphones User Manual

KINGSTATE ANC-TWS-S1 TWS Bluetooth Earphones

ANC-TWS-S1 Product Parameter

• Load impedance 320
• Operating voltage: earphone 3.7V
• Battery capacity: earphone 70mAh Charging box 800mAh
• Frequency range: 2.402G-2.480OG
• Charging time :1.5 hours
• Battery life: 1000 times
• Maximum noise deduction: >-26dB
• water proof level: 1PX5
• Bluetooth version: V5.1
• Sensitivity: 94 dBmn
• Weight: 6g for single earphone; 54g for charging box
• Charging box 3.7V
• The above data are all from the laboratory and for reference only.

Points for Attention On Battery

• The device can be powered by a built-in rechargeable lithium battery. Charge the device for at least 8 hours before first-time use.
• Rechargeable batteries can only be recharged under adult supervision..
• Only the attached Type-C cable can be used to charge the battery. Wireless charging is also possible. Incorrect charging can damage batteries and equipment.
• Do not attempt to open rechargeable batteries or battery packs. There are no usable parts in it.
• Keep the battery out of reach of children. If children swallowed it, please take them to the hospital immediately.
• Do not throw the battery into the fire, otherwise it may explode. Batteries may also explode if being damaged, please handle and disposal it according to local conditions and regulations.

Enter Pairing Mode

When the charging case are opened for the first time,the lights in earbuds flash mean into pairing mode, it takes about 10 seconds

Equipment matching

Turn on the “Bluetooth” function of the mobile phone and search “ANC TWS-S1” to connect. The prompt “connected” appears after successful pairing. When the device is successfully matched, both the blue and white light will turn off at the same time, then the blue light wil turn to slow flash.When replacing the connected device, please disconnect or unpair the device in the bluetooth control panel and enter standby mode after disconnecting.

Charging to The Charging Box

Connect the attached USB type-c cable to the USB interface of the charging device to charge the charging box. it takes about 1.5 hours to Tully charge the earphone and charging box.

Indicator light status of charging box:

• white light flashing: being charging
• l white light on: insufficient power
• 4 white lights on: charging completed

Mobile charging

Put the earphone into the charging box, and pay attention to the left and right sides. The magnetic suction of the charging box will adjust the earphone to the right position. It takes about 2 hours for the earphone to be fully charged on the left/right. Start Charging will be started once upon the blue light is constantly on.
Earphone indicator light status:

• Blue light is constantly on: earphones are being charged
• Blue light is off: earphones are fully charged

Wireless charging

Place the charge box on the center of wireless charger at proper position. The led indicator of charger box will flash from left to right. The indicator is always on after fully charged. It takes about 4 hours for fully charging the box and earphones.

wireless charging led indicator status

• LED flashes, the box is being  charged
• LED always being on, the box is fully charged

Product Dimensions

Operation of The Touch Panel

• Left ear
  • Tap Pause/Play/answer call /hang up call
  • Double click to switch transparency mode, ANC ON and ANC OFF.
  • Click 3 times for Voice Wake Up
  • Press 12S continuously to restore the factory Settings
  • Long press 2S for last song
  • Long press 5S to turn if off
• Right ear
  • Tap Pause/Play/answer call /hang up call
  • Double click to switch transparency mode, ANC ON and ANC OFF.
  • Click 3 times for Voice Wake Up
  • .Press 12S continuously to restore the factory Settings
  • Long press 2S for last song
  • Long press 5S to turn if off

If the device can not work properly,

• please click the following steps to reset the unit.
• If there are only one ear has sound, please put the device in charging case and close it, then open the case again,the earbuds are rematched when earbuds light flashing
• If only one earbuds has voice, mean matching failure, please click the following steps to restore the factory settings this device.
•  Take the earbuds out of the charging case and long press earbuds for five seconds to turn it off.
•  Press and hold the left and right earbuds at the same time. It takes about 12 seconds to turn off the earbuds. please follow these steps to enter automatic pairing mode
• Simultaneously press the earbuds for five seconds to turn it on, and enter the automatic pairing mode with flashing lights.
•  Put the earbuds back to the charging case, then open the case again, into the automatic pairing mode when the earbuds’ lights flashing.

Points for Attention

• To ensure the normal use of battery, if the earbuds are not used for long time, please put the earbuds into the charging case, so as to avoid loss of power and influence of playing time when the earbuds cannot be automatically shut down in the ANC and Transparent mode.
• The risk of hearing loss can be reduced by following the following safety guidelines when using this product: When connecting the headset, adjust the volume control to a minimum, and then slowly adjust the volume to a comfortable degree. Keep the volume as low as possible.
• If the volume needs to be increased, please adjust the volume control slowly. And stop using the speaker immediately if you feel unwell in the ear or if you got tinnitus. Using a high volume for a long period of time will make your ears used to such volume, causing permanent damage to your hearing even without any apparent discomfort. you are wearing a pacemaker or other electronic medical device, you should seek your doctor’s advice before using this product.
• The packaging contains small parts that can endanger children. Therefore, it should be kept out of the reach of children. Swallowing plastic bags can cause suffocation.
• Do not attempt to disassemble the product or insert any object into the product by yourselt, otherwise it may cause a short circuit, which may lead to fire or electric shock.
• Customer shall not replace or repair any component. Only authorized dealers or repair service center can open finished products. If any part of the product needs to be replaced for any reason (including normal wear and tear and damage or cracking), please contact the vendor
• Avoid rain, dampness or contact with other liquids.
• If the product is overheating, falling or damaged, or the product falls into a medium liquid, please stop using it.
• Using headphones while driving may be restricted by local laws. Please consult the local authority. Be caretul when using this product when you need to devote yourself to something else.
• Maintenance of built-in battery. The product is powered by rechargeable batteries. New batteries must be recharged and discharged two or three times before their full function be released. Disconnect from the charger when the battery is fully charged, as overcharging can shorten battery life. When not in usage, the charge in a fully charged battery slowly disappears. LDo not place the product near a heat source or expose it to direct sunlight, dust, moisture, rain or mechanical impact. Try to keep the battery temperature between 0°C and 45°C at àll times. If the battery is too hot or too cold, the product may not work temporarily, even if it is fully charged.
• Warning on battery Improper use of batteries may result in fire or chemical burns. Batteries can explode if damaged.
• Please refer to the User Manual for Instructions on the charging status indicator lights.
• When unplugging the power cord or any reinforced parts, please hold the plug and pull it out instead of pulling the cord directly. Do not use the damaged charger.

External Device Connection

• Please use the adapter which is specially provided for this product to charge the battery.
• Disposal of batteries shall be done according to local regulations. Cycle use the battery as much as possible.
• Do not dispose of batteries as household waste or throw them into fires, so as to prevent them from exploding,
• Unless otherwise specified in this User Guide or the Quick Start Guide, the user shall not remove or replace the battery by himself. Such operations may damage the product.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>