MPOW MP0W059 PLUS ANC Wireless Headphones User Manual
- June 5, 2024
- MPow
Table of Contents
MPOW MP0W059 PLUS ANC Wireless Headphones
Package List
Diagram
Power ON/ OFF
- Power on: Press and hold the MFB for 2 seconds, with blue light flashing for 1 second until you hear the voice power on.
- Power off. Press and hold the MFB for 5 seconds, with red light flashing until you hear the voice “power off.
**How to Pair
**
- Press and hold the MFB for 5 seconds to enter the paring mode, with red and blue flash alternately and the voice pairing’ heard.
- Tun on Bluetooth function on the phone. search “MPOW O59 PLUS and click to connect The voice connected” will be heard after the successful connection
Volume Control/Music Control
Play/ Pause/Answer a Call/Hang up a Cal/ Reject a
Call
Clear Pairing Record
Charge the Headphones
FCC Statement
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules Operation is subject to the following two conditions:
- This device may not cause harmful interference
- This device must accept any interference received, including interference that may cause undesired operation.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment This equipment has been tested and found to comply with the limits for a Class B digital device. pursuant to part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one ormore of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help
www.xmpow.com / support@xmpow.com