Asiatelco Technologies AS31 Battery Powered Asset and Vehicle Tracker User Manual

Asiatelco Technologies AS31 Battery Powered Asset and Vehicle Tracker

Ideal for stolen vehicle, goods or other assets to be tracked with no installation process required. The battery-powered, small-size AS 31 GPS tracker is designed to be used with internal non rechargeab le battery only for fast installation. It is a Slap & Track GPS trac ker. The AS31 provides asset location tracking and receiving alerts when the asset has been moved or tampered with, plus many more features.

ITS RELIABLE
The AS31 is a high-performance, IP67 rated device. It includes an i ntegrated LTE Cat.Ml modem, a GNSS receiver, and a 3-axis accele rometer, for cellular data communication, location tracking, and mot ion detection respectively.

ITS SIMPLE
With Non-chargeable batteries the AS31 can be easily used anywh ere the tracking is required. AS31 can be programmed to wake-up on motion, upon a preset schedule. Reports can be triggered periodi cally or in response to events – such as removing, movement, geo-f ence violations, and many others.

ITS FUNCTIONAL
The AS31 comes with pre-configured software. Its internal motion sensor and configurable event alarms enable total management of your high-value assets. The device supports variable frequency rep orting when moving or stationary.

Specifcations

CELLULAR

• CAT M1 LTE: 699/787 /1710/1850/2155.
• B2@20±1dBm/ B4@20±1dBm / B12@18±1dBm.
• B13@18±1 dBm /B25@20±1 dBm.
• Integrated high performance antenna.
• Auto register to LTE network.

GPS

• Channels: 55.
• Tracking Sensitivity: -161 dBm.
• Acquisition Sensitivity: -146 dBm.
• Location Accuracy: <2.5 CEP.

SENSOR

Accelerometer : 3x

BATTERY INFORMATION

• Type : non-rechargeable battery
• Capacity : 6000mAh @ 3.0V
• Operating Time : Up to 5 years @ 1 report per day Depends on the LTE signal strength and how ma ny reports per hour.

ENVIRONMENT AL

• I P67 Rating
• Operation Temperature : -30°C to +75°C.
• Storage Temperature : -40°C to +85°C.

ELECTRICAL

• Operating Current.
• Sleep/Hibernate: < 20uA.
• Tracking 150mA Typical.
• Reporting: 250mA Typical.

PHYSICAL

• Dimensions : 96.7 x 44.5 x 30.5mm e Weight : <150 g.
• Internal Cellular and GNSS Antenna.

INTERFACE I Os (for maintenance only)

• 1/0 Connector : 5-pins water-proof (POGO Pin)
• UART1 TTL (3.3V) (RX/TX) (*2)
• Two GPIOs (*2)
• GND (*1)

APPROVALS

• FCC
• PTCRB & Carrier Approved.

FCC Regulations

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/ TV technician for help.
• Changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment.

FCC RF Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. To comply with FCC RF Exposure compliance requirements, this grant is applicable to only Mobile Configurations. The antennas used for the transmitter must be installed to provide a separation distance of at least 20cm from all persons and must not be co‐located or operating in conjunction with any other antenna or transmitter.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>