Funrise F82440 CAT Massive Mover Instructions
- June 5, 2024
- Funrise
Table of Contents
F82440 CAT Massive Mover
Instructions
Massive Mover RC 2.4 GHz
BATTERIES
CHARGING
- Remove the 6.4V lithium rechargeable battery pack from the truck following the diagram above, and connect it to included USB cable adaptor.
- Connect the adaptor to the computer USB output, or to AC power adaptor with an output limit of 6.4V for charging.
- The full charge is about 3 hours at 5V (Computer USB port).
- When charging is completed, unplug the USB cable adaptor.
- Disconnect the rechargeable battery pack from the USB cable adaptor, and re-connect it back to the truck. Reinstall the battery cover tightly.
CHARGING INDICATOR
| Power On: | Red light |
|---|---|
| Charging: | Blinking Red light |
| Fully charged: | Red light OFF |
| Battery error: | RED light Strobe |
For 700 mAh, Please note to disconnect the charger when the RED light turns OFF.
TIPS
- The operating range can be affected by low voltage of batteries or interference from other external sources.
- Outdoor usage is recommended for optimal control range.
- Clean battery compartment to make sure it is free from dust to the previous contact of batteries.
- Headlights will automatically turn on when driving.
PARING VEHICLE/CONTROLLER TIPS
- Turn on the vehicle; headlights will flash to indicate Pairing Mode.
- While headlights are flashing, press any button on the controller; the controller light should turn on while pressing.
- The headlight will stop flashing to indicate successful Pairing.
- If paring is not completed within 5 minutes, please turn off the vehicle and re-start from step 1.
NOTE: After 5 minutes of inactivity, the vehicle will enter sleep mode. Turn the vehicle OFF and then ON again to resume the connection.
OPERATION PRECAUTIONS
- Do not drive on tall grass, sand, or go thru the water.
- Do not drive in rainy weather.
- Avoid direct impact with obstacles.
- Switch OFF power when not in use to prevent damage to vehicle and transmitter from battery leakage.
- Keep fingers, hair, and loose clothing away from moving parts.
OPERATION
F Forward
B Back
L Left
R Right
D Dump
+ Fast
– Slow
BATTERY PRECAUTIONS
- The 6.4V lithium rechargeable battery pack must be charged before use by utilizing the included USB cable adaptor.
- Do not charge for more than 6 hours.
- Do not charge the battery pack if it shows leakage, corrosion, or has loose or exposed wires or other damage.
- Do not cover the battery pack while charging.
- Do not dismantle the battery or charger, and do not cut the battery or charger cables.
- The battery pack will be warm after charging. Do not touch the battery pack when it is hot. Wait until the battery pack cools before installing it in the Vehicle and before recharging.
- The supply terminals are not to be short-circuited.
- Rechargeable batteries and replacements are only to be made by adults.
- The USB cable adaptor is not a toy.
- This charger is intended to be used for charging a 6.4V rechargeable battery pack with a capacity (700mAh Max.) Other types of batteries may burst to cause injury to persons and damage. It cannot be used for charging non-rechargeable batteries. Regular examination of battery charger for any damage to their cord, plug, enclosure, and other parts, and that, in the event of such damage, it must not be used with the charger or battery pack.
- Note that the AAA battery is non-rechargeable and is not to be recharged. Only batteries of the same or equivalent type as recommended are to be used. It will need replacement when the transmission is poor.
- Exhausted batteries are to be removed from the product.
- Different types of batteries or new and used batteries are not to be mixed.
- Rechargeable batteries are to be removed from the toy before being charged.
- Batteries are to be inserted with the correct polarity (+/-) as shown inside the battery compartment.
- Do not dispose of batteries in fire.
WE RESERVE THE RIGHT TO IMPROVE/AMEND SPECIFICATIONS AND COLORS WITHOUT NOTICE.
CONTENTS
CAUTION
- DO NOT RECHARGE THE BATTERY PACK THAT SHOWS LEAKAGE OR CORROSION.
- IF THE BATTERY PACK IS HOT AFTER USE, ALLOW IT TO COOL BEFORE RECHARGING.
- DO NOT ATTEMPT TO DISASSEMBLE THE VEHICLE OR CONTROLLER.
- THE PACKAGING AND INSTRUCTION HAVE TO BE KEPT SINCE IT CONTAINS IMPORTANT INFORMATION.
WARNING! CHOKING HAZARD. NOT FOR CHILDREN UNDER THE AGE OF 3.
FCC label compliance statement:
This device complies with part 15 of the FCC rules Operation is subject to the
following two conditions: 1. This device may not cause harmful interference,
and 2. This device must accept any interference received, including
interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
©2020 Caterpillar.
CAT, CATERPILLAR, their respective logos, “Caterpillar Yellow “Power Edge”
trade dress as well as corporate and product
identity used herein, are trademarks of Caterpillar and may not be used
without permission. www.cat.com Funrise Inc., a licensee
of Caterpillar Inc.
Conforms to the safety requirements of ASTM F963
Frequency band: 2408 – 2475 MHz
Maximum radio frequency power transmitted: <10 dBm