WELMAG WMT100-CS Remote Controller User Manual
- June 4, 2024
- WELMAG
Table of Contents
WMT100-CS Remote Controller User Manual
Function Introduction
- Fan OFF / Pairing key
- Fan Forward / Reward
- Fan speed up
- Fan speed down
- Timer
- Natural wind
- Lighting down (dimming)
- Lighting ON / OFF
- Lighting up (dimming)
Pairing Method
Press and hold the Key 1 for 2~3 seconds within 1 minute when Fan power
on.
You will hear 3 sound of “Beep”. It means pairing is successful.
Tips:
The remote control has been paired before leaving the factory and it can be
used directly after installation. Re-pairing is required when you need to
replace a new remote.
Specification
| Model | WMT100-CS |
|---|---|
| Frequency | 433.92 MHz |
| Size | 112(L)43(W)12 (H) mm |
| Working Distance | 12-15 meter (open space) |
| Battery | CR2032 |
| Voltage | DC 3V |
Notices
Warning: Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user’s authority to operate
the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Shenzhen WELMAG Intelligence Technology Co. Ltd.
5th floor, Building 3, Hongtu Industrial Zone, North Seventh Road,
Hezhou, Bao’an District, Shenzhen.