HOVER-1 S-200 Light with Turn Signals User Guide

HOVER-1 S-200 Light with Turn Signals

FEATURES

• Strobe Mode
• Wireless
• Turn Signal

CONTENTS

• Safety Light
• Remote Control
• Bike MOunt
• Helmet Mount
• Handlebar Mount
• Micro US8 Cable
• 2032 8utton Battery

REMOTE FUNCTIONS

• Please note, there is an acceleration sensor built into the safety light. Both acceleration and deceleration will activate the light.

POWER ON/OFF

Press and hold power button for 3 seconds to turn on/off the device

• Press Once: Turn on left blinker
• Press Again: Turn off left blinker
• Press Once: Turn on right blinker
• Press Again: Turn off right blinker
• Press Once: Turn on flashing lights
• Press Again: Turn off flashing lights

CHARGING INSTRUCTIONS

• To charge the battery, open the charging flap and insert included Micro USB cable
• When charging, a red indicator light will appear
• When fully charged, the indicator light will turn green

HELMET MOUNT

• Take the double-sided adhesive provided and attach one side to the mount
• Place the mount on your helmet and press firmly
• Slide safety light into mount

HANDLEBAR MOUNT

• Wrap the mount around your handlebar and tighten until it’s secure
• Place your remote into the mount

BIKE MOUNT

• Place mount around a bar on your bike
• Use the provided screw to tighten the mount until secure
• Slide the safety light into place

BATTERY CHANGE

• To open the battery cover, use a coin to twist it counter-clockwise. Then remove the cover.
• Remove the old battery, place in the new battery.
• Replace the cover and use a coin to twist it clockwise to close it.

FCC STATEMENT

This device complies with part 15 of the FCC Rules.
Operation is subject to fine following Two conditions:  This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Please note that changes or modifications not expressly approved by the party responsible for compliance could vold the user’s authority to operate the equipment.

FCC INSTRUCTIONS FOR A CLASS B DIGITAL DEVICE OR PERIPHERAL
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant fo part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful inferference in a residential installation. The equipment generates, uses, and can radiate radio frequency energy, it is not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment info an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>