veea VHE09 Smart Computing Hub User Manual
- June 5, 2024
- veea
Table of Contents
veea VHE09 Smart Computing Hub
Model Name
As stated on agency label
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
- This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Responsible Party – U.S. Contact Information
Veea Inc
164 E 83rd Street, New York NY, 10028
+ 619-787-5225
https://www.veea.com/
UL (In use for limited model: VHE09 series and VHE10 Series only)
To reduce potential safety issues, only the AC adapter provided with the
product, a replacement AC adapter provided by VEEA Inc., or an AC adapter
purchased as an accessory from VEEA Inc., should be used with the product.
This product is only to be connected to PoE networks without routing to
outside plants.
Risk of Explosion if Battery is replaced by an Incorrect Type. Dispose of Used
Batteries According to the Instructions.
Federal Communications Commission
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to pro-vide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radiofrequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Radiation Exposure Statement
The product shall be installed at a location where the radiating antenna can be kept 29 cm from nearby person in normal operation condition to meet regulatory RF exposure requirements.
Note: The country code selection is for non-US model only and is not available to all US model. Per FCC regulation, all WiFi product marketed in US must fixed to US operation channels only
This device meets all the other requirements specified in Part 15E, Section
15.407 of the FCC Rules.
To reduce potential safety issues, only the AC adapter provided with the
product, a replacement AC adapter provided by VEEA Inc., or an AC adapter
purchased as an accessory from VEEA Inc., should be used with the product.
Warning
- At first before powered on, connect the frame of the unit to earth.
- For earthing wire, green-and-yellow insulation is required and the cross-sectional area of the conductor must be more than 0.75mm2 or 18 AWG.
- The product shall be installed by a skilled person and the installation shall conform to all local codes..
This unit contains a CR2032 coin cell battery.
CAUTION: Risk of explosion if battery is replaced by an incorrect trpe.
Dispose of used batteries according to the instructions.
Professional installation instruction
-
Installation personal
This product is designed for specific applications and needs to be installed by a qualified personnel who has RF and related rule knowledge. The general user shall not attempt to install or change the setting. -
Installation location
The product shall be installed at a location where the radiating antenna can be kept 29 cm from a nearby person in normal operating conditions to meet regulatory RF exposure requirements. -
External antenna
Use only the antennas which have been approved by the applicant. The non- approved antenna(s) may produce unwanted spurious or excessive RF transmitting power which may lead to the violation of FCC limit and is prohibited. -
Installation procedure
Please refer to user’s manual for the detail. -
Warning
Please carefully select the installation position and make sure that the final output power does not exceed the limit set force in relevant rules. The violation of the rule could lead to serious federal penalty.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>