VHE09-4GL Veea Smart Computing Hub User Manual

June 5, 2024
veea

VHE09-4GL Veea Smart Computing Hub
User Manual

Model Name
As stated on the agency label

FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference, and
  2. this device must accept any interference received, including interference that may cause undesired operation.
  3. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Responsible Party – U.S. Contact Information
Veea Inc
164 E 83rd Street, New York NY, 10028
+ 619-787-5225
https://www.veea.com/

(SIGNATURE / DATE)

UL (In use for limited models: VHE09 series and VHE10 Series only)
To reduce potential safety issues, only the AC adapter provided with the product, a replacement AC adapter provided by VEEA Inc., or an AC adapter purchased as an accessory from VEEA Inc., should be used with the product.
This product is only to be connected to PoE networks without routing to outside plants.
Risk of Explosion if Battery is replaced by an Incorrect Type. Dispose of Used Batteries According to the Instructions.

Federal Communications Commission
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial environment This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used inaccordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Radiation Exposure Statement:
The product shall be installed at a location where the radiating antenna can be kept 29 cm from a nearby person in normal operating conditions to meet regulatory RF exposure requirements.

Radiation Exposure Statement:
The product shall be installed at a location where the radiating antenna can be kept 29 cm from a nearby person in normal operating conditions to meet regulatory RF exposure requirement.
Note: The country code selection is for non-US models only and is not available to all US models. Per FCC regulation, all WiFi products marketed in the US must fix to US  operation channels only Operations in the 5.15-5.25GHz band are restricted to indoor usage only.
This device meets all the other requirements specified in Part 15E, Section 15.407 of the FCC Rules.
To reduce potential safety issues, only the AC adapter provided with the product, a replacement AC adapter provided by VEEA Inc., or an AC adapter purchased as an accessory from VEEA Inc., should be used with the product.

Warning:

  • At first, before powered on, connect the frame of the unit to the earth.
  • For earthing wire, green-and-yellow insulation is required and the cross-sectional area of the conductor must be more than 0.75mm2 or 18 AWG.
  • The product shall be installed by a skilled person and the installation shall conform to all local codes.

This unit contains a CR2032 coin cell battery.
CAUTION: Risk of explosion if the battery is replaced by an incorrect type. Dispose of used batteries according to the instructions.

Professional installation instruction

  1. Installation of personal
    This product is designed for specific applications and needs to be installed by a qualified person who has RF and related rule knowledge. The general user shall not attempt to install or change thesetting.

  2. Installation location
    The product shall be installed at a location where the radiating antenna can be kept 29 cm from a nearby person in normal operating conditions to meet regulatory RF exposure requirements.

  3. External antenna
    Use only the antennas which have been approved by the applicant. The non- approved antenna(s)may produce unwanted spurious or excessive RF transmitting power which may lead to the violation of FCC limit and is prohibited.

  4. Installation procedure
    Please refer to the user’s manual for the detail.

  5. Warning

Please carefully select the installation position and make sure that the final output power does not exceed the limit set force in relevant rules. The violation of the rule could lead to a serious federal penalty.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals