Memsor B2860 LifeTemp Thermometer User Guide
- June 5, 2024
- Memsor
Table of Contents
Memsor B2860 LifeTemp Thermometer User Guide
Box Includes
- LifeTemp Thermometer X 1
- CR1620 Battery X1
Pairing
- Press and hold the button on the device for 5 seconds to power on.
- Go to “Settings” > “Device”.
- Tap the “Add Device” button.
- Choose the device you want to connect while pressing and holding the button on your device.
Once connected the device will flash green lights.
Warning
- Do not place device in surroundings where temperatures surpass 80°C as the magnet will demagnetize.
- Do not place device near anywhere that might get affected by magnets.
- Do not disassemble, charge, crush or expose to fire or high temperatures.
- Keep out of reach of children.
- Do not take apart the device except for changing the battery.
- Children under 12 and the elderly needs to be supervised when using this device.
- Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NCC Statement
(Administrative Regulations on Low Power Radio Waves Radiated Devices)
Article 12:
Without permission granted by the NCC, any company, enterprise, or user is not
allowed to change frequency, enhance transmitting power or alter original
characteristic as well as performance to a approved low power radio-frequency
devices.
Article 14:
The low power radio-frequency devices shall not influence aircraft security
and interfere legal communications; If found, the user shall cease operating
immediately until no interference is achieved.
The said legal communications means radio communications is operated in compliance with the Telecommunications Act.
The low power radio-frequency devices must be susceptible with the interference from legal communications or ISM radio wave radiated devices.
FCC Statement
Part 15B compliance statement:
NOTE:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Disclaimer & Warranty
For full disclaimer, warranty details and FAQ, please visit our website:
www.LifeTemp.co
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>