ADEPT INDUSTRIES V2.0 SENSOR Tether Follow Sensor User Manual
- June 5, 2024
- ADEPT INDUSTRIES
Table of Contents
INDUSTRIES V2.0 SENSOR Tether Follow Sensor
User Manual
ModelV2.0
V2.0 SENSOR Tether Follow Sensor
- Power on Press the power button, and the blue indicator light starts to shine
- BLE matching code: First turn on the power of eWheels, and then press the TFS power switch for more than 3 seconds in the shutdown state. The blue LED starts flashing rapidly, and the TFS enters the matching state. When the blue LED continues to shine, the matching code is successful. If the blue LED is flashing slowly, the code alignment failed. Please try again.
- After successful yard matching and BLE connection, fix TFS on the golf bag and pull the opening of the rope towards the Head of eWheels.
- Buckle the iron clip to the belt and attach the magnet to the clip. When you walk forward, the rope is pulled out, and when it is more than 1 metre, eWheels follow at your pace. When you turn, eWheels follow the turn; When you stop, eWheels stop.
FCC STATEMENT:
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF warning statement:
The device has been evaluated to meet the general RF exposure requirement. The
device can be used in portable exposure conditions without restriction.
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
- this device may not cause interference, and
- this device must accept any interference, including interference that may cause undesired operation of the device.”
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>