ADEPT INDUSTRIES V2 Club Booster User Manual
- June 5, 2024
- ADEPT INDUSTRIES
Table of Contents
INDUSTRIES V2 Club Booster
User Manual
V2 Club Booster
eWheels V2 user manual
- Power on: EWheels will display the current battery level and automatically enter the braking state.
- Press the SPEED_UP button on the remote control and the eWheels begin to move. As you advance, press the buttons SPEED_UP and SPEED_DOWN on the remote control to speed up or slow down. Whenever the STOP button on the remote control is pressed, eWheels STOP.
- Pressing the STOP button on the remote control for more than three seconds causes eWheels to unbrake and be in a free state.
FCC STATEMENT:
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: This device may not cause harmful interference,
and
FCC STATEMENT:
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20cm between the radiator & your body.
” This device complies with Industry Canada licence-exempt RSS standard( s).
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.”