Pro Co WIEMS Wireless In-Ear Monitor System User Guide
- June 5, 2024
- Pro Co
Table of Contents
Pro Co WIEMS Wireless In-Ear Monitor System
CONGRATULATIONS!
On your purchase of the new ProCo W.I.E.M.S. The music industry’s most compact and lightweight wireless ear monitoring system on the market today.
Package contents
- Hardshell case with accessory pouch
- Receiver
- Transmitter
- AC/DC charger adaptar
- Charging-cable”
- Instruction manual
- Registration/warranty card
Features
- Crystal clear 24 bit/48KHz digital tranomisoion
- Operates at 5.8GHz (free from competing for wi-fi traffic)
- Compact, lightweight, aluminum belt pack
- No external antennas
- Simple Plug-N-air system
- Low Latency (<5 6na)
- 20 to 30-meter range (lo.s)
- Uses an internal rechargeable battery
- 6-8 hour battery life per charge
- Four selectable channels
- Accepts a line-level signal
- Up to 4 Systems can be used simultaneously
The actual range can be affected by environmental conditions of Sige s highly 0ccm take test portulaca)
System Specifications
- Transmission Format: 5 8GH, 24b4 Digital Wireless
- Frequency Response: 40He to 20
- Frequency Selection: 4 selectable channels
- SN Ratio: More than 90 dB (A-weighted)
- Distortion: <0 12%THD
- Headphone Connector: 1/8 (3.5mm) TRS Stereo
- Max Input Level: 1.75Vms
- Max Output Level: 127miW per channel
- Rechargesble Bsttery Lite: 6-8 hous
- Power/Charging input: 5vDC. 500 mA (Micro USB)
W.I.E.M.S. RECEIVER: (Belt-Pack)
- Power: Press and Hold Power Buton for 2 seconds 1o turn on. then release To turn off, hold Power Buton down for 3 seconds
- Volume: Rotate the knob on top of the receiver clock-wise to adjust the volume
- Power LED and Pairing: LED Solid green LED indicates power on A flashing blue LED indicates Pairing Mode while a solid blue LED indicates nit is “Pre
- Headphone Jack: 1/8 (3 5mm TRS Stereo
NOTE Normally or Hecoeer receivers are automatically connected to the or trimester, turn pairing is temporary, sippy gress d Heidt Pae Bunoei for 5 seconds then rouse the LED with big Modo) A solid take will date.
Caution: Using this tom at high volume lev can heng damage)
W.ILE.M.S. TRANSMITTER
- Power: Press and hold for 2 seconds to turn on, then release Press and hold for 3 seconds to turn off
- Pair Button: Channel Select-(see Additional Operating Instructions on next page)
- Charging Port: Pug micro-USB cable here to charge
- Status LEDs: Solid green LED indicates
- Power On A flashing blue LED indicates
- Paring Mode and a sold blue LED indicates
- Pared The blue LED will to indicate channel selection (See Additional Operating Instructions)
Additional Operating Instructions
Although your new W.IEMS was paired& fully charged at the factory before shipping we recommend you charge both units tor approximately 2 hours before use.
Battery: When either unit is on. an alternating flashing red and green
LED indicates the battery is low and in need of charging The green LED will
flash once per second when charging When the green LED goes out while
charging and the unit is off, it is fully charged You should get 6-8 hours of
continuous use from a single charge. The Transmitter can be used while
charging
Selecting channels: With the system on, quickly press and release the
transmitter “Pair button. the Blue LED will flash represerting the channel
selected Repeat this process unt the desired channel is obtained
Pairing: With the receiver off. power on the transmitter Hold down the
transmitter’s Par button for 5 seconds and release The blue LED will blink
slowly (about once per second) Power on the receiver, and the blue LED will
start blinking tast and pair lo the transmitter automatically (solid blue
LED). On occasionit may be necessary to put both units in pair mode
Powering off: Press and hold power in tor 3 seconds to power units off.
FCC Compliance and Certifications
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These imits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will does not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment should be installed and operated with a minimum distance of 20cm between the radiator& your body
WARNING: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. The device must not be co-located or operating in conjunction with any other antenna or transmitter This device complies with FCC radiation exposure limits set forth for an uncontrolled environment.
- www.procosound.com
- 3681 Larch Lane
- Jackson, MO 63755