E Care Technology HE-T03 BT Wireless LED Headphone User Manual
- June 5, 2024
- E Care Technology
Table of Contents
HE-T03 BT Wireless LED Headphone
User Manual
BT DUAL HEADPHONE
Package Contents:
– 1 (One) BT Wireless LED Headphone
– 1 (One) Micro USB Charging Cable
– 1 (One) Instruction Manual
Button Description:
“ “ON/OFF Pause/Play Music
” +”: Short press to increase volume / long press for the Next song
“_ “: Short press to reduce volume / long press for the Previous song
How To Use:
- Power on: Press the key “ ” 2 seconds when it is off. The blue LED light will turn on. and begin to alternate blue red LED light A voice will prompt ‘pairing”. indicating the headphone is in pairing mode.
- Pairing: Activate the Bluetooth function on your phone within range and select BT DUAL HEADPHONE ‘ from the list shown. When the dueled LED tight stops flashing, it has paired successfully and you will hear” connected -. The blue LED will flash slowly when playing music.
- Play/Pause: When it is playing, press the key “ ” to pause, then press the key “ ” again to play.
- Volume up: Press -+- once to increase the volume.
- Volume down : Press “- once to decrease the volume
- Previous song: Hold down the’- to play the previous song
- Next song: Hold down the -4.- to play the next song
- Phone Call: Press -,t5- to answer/end a call. Press and hold “ ” for about 1.5 seconds to reject an incoming call.
- Power off: When the headphone is on standby or in operation, press the key “ ” 3 seconds to shut down the headphone (voice prompt “power off’).
Tips:
- Low Battery: LED light flashes red.
- To Charge:
- Insert the USB connector end of the included cable (see packing list) into the USB jack on the charger or USB port on the computer.
- The indicator light will be red while charging.
- When the headphone is fully charged. the indicator light will turn from red to blue. Please unplug your charger from the power source.
- Please use a qualified charger to recharge your headphone. If not. it may result in damage or even an explosion.
- Repeated charging and discharging of the headphone will lead to decreased battery life over time. which is normal for rechargeable batteries.
- You must charge the Bluetooth Headphone if it has not been used for more than 6 months.
Technical Specifications:
- Model Number: MU01038
- Battery Capacity: 3.7 V / 200 mAh
- Play Time: 3-4 hours
- Charge Time: 2-3 hours
- Frequency: 20Hz – 20kHz
- Impedance: 32 ohms
- Working Distance: 10 m
- Charging Way: USB DC 5V
- Operating temperature range 0-45(
FAQ
- Why can’t I start my Bluetooth headphone? Answer: Please ensure that the headphone is fully charged for your first use.
- Why won’t sound come out of the headphone? Answer: Check whether the playback device and the Bluetooth headphone are successfully established. If the audio device is not properly connected. please reconnect. Please also adjust your mobile phone or Bluetooth headphone volume to a suitable volume level.
- Why can’t I find these headphones in my Bluetooth options? Answer: Make sure the Bluetooth is invisible mode-. If no pairing occurs. the Bluetooth function will automatically shut off. Please reopen Bluetooth to “visible mode-. If there is a program error. please reboot your phone. and if a program error is caused by your Bluetooth headphone. please restart the headphone.
FCC statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference. and (2) this device must accept any interference received.
including interference that may cause undesired operation.
NOTE
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates. uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions. may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception. which can be determined by turning the equipment off and
on. the user is encouraged to try to correct the interference by one or more
of the following measures
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
WARNING: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
WARNING: This product can expose you to chemicals including Bisphenol A
(BPA), which is known to the State of California to cause birth defects or
other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
WARNING:
- Charge and operate only as indicated in this manual, as improper use may result in damage to the product or Injury.
- To avoid the risk of shock or injury, do not dismantle the device or Insert any objects into the Headphone.
- To avoid electronic Interference and/or compatible conflicts, turn off the product In any facilities where posted notices instruct you to do so.
- Do not pull the Headphone charging cable. Damage may result in the cable.
- Keep out of reach of children. This Is not a toy.
- Avoid exposure to moisture, liquids, heat, flame, and high voltage equipment.
- Retain these instructions as they contain important information.
- Do not short circuit the input terminals of the Headphone.
- Do not drop, place heavy weight or allow heavy Impact to the Headphone.
- PCB of battery should not be crushed and twisted
- The battery body should not be Bended.
- Do not disassemble and Do not dispose of in fire.
- Do not use the product while driving or crossing the road. RF warning statement: The device has been evaluated to meet the general
RF exposure requirement
The device can be used in portable exposure conditions without restriction.
FCC ID: 2AW5BMU01038
Distributed by 1616 Holdings, Inc. 701 Market Street, Suite 200 Philadelphia.
PA 19106 Made in China
Keep All Relevant Information For Future Reference