LeadingPlus LP-UN-313-2 Multifunction UV Sterilizer User Guide
- June 5, 2024
- LeadingPlus
Table of Contents
LeadingPlus LP-UN-313-2 Multifunction UV Sterilizer
Technical Specifications
- UV sterilizing power: 2W*2
- Type-C input: 9V/2A 5V/2A
- USB output:5V/2A
- Wireless output:5V/2A
- Weight: 354g
- Sterilize： Mobile phone, iPod, Mp3 player, Wireless earphones, Watches, Keys, Jewelries etc.
What’s in the box
-
Type-C USB Cable
-
UV Sterilizer
UV Sterilizer Overview
- UV lamp
- LED indicators
- LED display/Button
- USB output port
- Type-C input port
- Buzzer
- Lid
- Infrared sensor
- Wireless charging
How to Use
UV Sterilizing
-
Plug in Type-C cable, connect UV sterilizer to an adapter.
-
Put your phone inside, press the Button to turn on the UV lamps.
-
After 15 minutes, UV lamps automatically turn off, buzzer will “Beep”, disinfection process completed.
Note: When you open the lid, infrared sensor switch will detect it, UV lamps will automatically turn off.. When you close the lid, UV lamps will turn on again.
Wireless Charging
- Put your phone in UV sterilizer, it will wireless charge your phone.
Note:
-
Wireless charge only supports Qi-enabled phone.
-
Quick wireless charge only works with 9V/2A output adapter (not supplied).
-
Put your phone in the center of UV sterilizer. Please note wireless charge may not work on phones with thick case on.
-
If there are metal units between the phone and UV sanitizer, UV sanitizer will detect them, the green LED indicator will flash, please take out metal units.
USB Charging
- Plug in another charging cable, charge other phones or devices.
Note: If the output power of adapter is too low, sterilizing, wireless charging and USB charging will not work at the same time.
Safety information
- Do not drop or cause an impact on the device.
- Do not disassemble, modify or repair your device.
- Keep away from humidity and heat.
- Keep it beyond the reach of children.
Precaution!
- Metal objects placed on top of charging devices might result malfunction of the item and damage the charging device on top of it.
- Do not operate the item on top of any metal work table or surface.
FCC RULE
Warning:
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE：
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
NOTE：
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF exposure compliance statement:
This device has been evaluated to meet the general RF exposure requirement