TagMaster 195100 MarkTag Classic Long Range RFID Reader Installation Guide

TagMaster 195100 MarkTag Classic Long Range RFID Reader Installation Guide

About the identification Tag

The TagMaster Mark Tag Classic (product number: 225000) is designed to be used with TagMaster Long Range RFID Readers for access control and automatic vehicle identification applications.

The MarkTag Classic is a long–time proven high-end choice for vehicle identification within parking and access control. Easy to use, highly reliable, can be read from both sides, and is licence-free worldwide as it is using the 2.45GHz frequency band. The tag is placed behind the windshield using an easily installed WinFix placeholder (product number: 195100).

How to mount the Tag on your windshield

1. Position of the reader
   
   Place the Tag on the windshield, on the same side / as close to the reader as possible. If the reader is placed in a high position, place the Tag in the upper part of the windshield.
   Do not place the Tag on the side windows.

2. Where to put the Tag
   
   Suitable positions to mount the WinFix Classic placeholder.

3. Distance from the edges
   
   The WinFix Classic placeholder must have minimum 1 Inch or 3cm distance from the windshield edges. Tag performance will decrease if the holder is mounted close to metal or another RFID-tag.

4. Clean surface
   
   Make sure the surface is clean before applying the WinFix placeholder to the windshield glass

5. Apply the WinFix holder carefully
   
   The MarkTag Classic can be read in any orientation, but make sure to leave enough room to insert the Tag in the WinFix placeholder.

6. Insert the card in the holder
   
   The MarkTag Classic can be read in any orientation, but make sure to leave enough room to insert the Tag in the WinFix placeholder.

7. Sunscreen and metal
   

   • The Tag will not work if it is placed behind the sunscreen at the top of the window.
   • Do not put the Tag on a third party sunscreen foil attached to the windshield from the inside.
   • Do not mount the Tag on metal surfaces or on painted surfaces, as they the paint can contain metal particles. Metal close to the Tag impacts the Tag read-range negatively.

8. About the MarkTag
   
   MarkTag Classic emits no radio signals, it only reflects a modulated response to a reader request. As the tag electronics are always powered up and the power consumption is constant, the tag lifetime is predicted to +6 years, independently of the number of reads. As battery levels are getting low, the tag generates a battery low alarm to the reader, which can then inform the host systems when it is time to replace the card. The battery inside the tag/card can not be replaced.

www.tagmaster.com
[email protected]
Due to TagMaster’s continuous effort to develop the products in response to customer needs, the above specifications are subject to change.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>