Electrolux A25043301 Leveling Cabinet and Doors Instructions
- June 5, 2024
- Electrolux
Table of Contents
Electrolux A25043301 Leveling Cabinet and Doors
Leveling the cabinet using the leveling feet
- All 4 corners of the cabinet must rest firmly on the floor.
- Level the cabinet at the front and rear ensuring the doors will open, close, and seal properly.
- Align and level the doors with each other.
- • Open both doors and remove the toe grille (see Toe Grille Installation and Removal in the INSTALLATION section of your Use & Care Manual).
- • Level the cabinet at the front and rear so the front is raised ¼ in. (6 mm) above the rear. Close the doors and use a 9/16 in. wrench to raise (clockwise) or lower (counterclockwise) the front leveling feet.
- • Check the pull force on the handles after the unit has run for 5 minutes. This ensures an air-tight seal forms between the door gasket and the metal part of the cabinet.
Leveling the doors using the adjustable lower hinge
- Before leveling either door, remove set screw that locks door height into position using a 3/32 hex key. (See illustration 1.)
- If the freezer door is lower than the refrigerator door (2A) or the refrigerator door is lower than the freezer door (2B), raise the door by turning the adjustment screw counterclockwise using a 12 mm wrench (See illustration 3).
- After leveling, verify the door stop contacts the lower hinge and the top of the door does not contact the upper hinge through full movement of the door (from fully closed to fully open).
- Reinstall the set screw, locking the door height.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>