INTEX 56585 70cm Swimming Ring Baby Float Instructions
- June 5, 2024
- INTEX
Table of Contents
INTEX 56585 70cm Swimming Ring Baby Float
HOW TO INFLATE AND FIT
-
Inflate each section by mouth while squeezing the valve lightly at its base.
Note: It is very important to follow the numerical sequence; failure to do so will result in an improperly inflated baby float. Insert the stopper into the valve and recess the valve by pushing down firmly on it. Never overinflate or use high-pressure air to inflate. -
With the swim seat facing UP, position the child’s legs through the bottom front legs holes of the swim seat. The child’s body should be approximately upright. Be sure the swim seat fits around the child’s lower body securely, and the water level is at or about the level of the nipples.
HOW TO REMOVE AND DEFLATE
- Lift child out of the swim seat.
- Pull stopper out and squeeze the valve at its base until deflated.
- Rinse with water and air dry thoroughly before storing it. Place it in a safe storage area.
WARNING – RISK OF CAPSIZING
-
WILL NOT PROTECT AGAINST DROWNING.
-
ALWAYS FULLY INFLATE ALL AIR CHAMBERS.
-
USE ONLY UNDER CONSTANT SUPERVISION IN DIRECT REACH OF THE SWIM SEAT.
-
THE USE OF DIAPERS OR ANY OTHER APPAREL OR DEVICE SHALL NOT LEAD TO AN
ENTRAPMENT OF THE CHILD INSIDE THE SEAT. -
ALWAYS SUPERVISE IN DIRECT REACH OF THE CHILD.
-
CAPABILITY TO SIT UPRIGHT AS STARTING POINT TO USE SWIM SEATS.
-
DO NOT ALLOW CHILDREN TO BITE OR CHEW THE PRODUCT AS PIECES THAT MAY BE BITTEN OFF/TORN FROM/
COMING AWAY FROM THE MATERIAL MAY CAUSE A CHOKING HAZARD.
DO NOT USE
- By user beyond or below designated weight range/age;
- within child’s standing depth;
- in breaking waves;
- in bathtubs.
Mass: ≤11 kg, (for orientation only: this mass corresponds to an age group of 6 to 12 months). Not an aquatic toy.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>