abl Conference Desk Power Module User Manual
- June 5, 2024
- ABL
Table of Contents
abl Conference Desk Power Module
Product Introduction
Thank you for purchasing ABL’s Conference power module. 
INSTALLATION:
Note: Ensure that there is a sufficient clearance, 150mm below surface and 30mm between the cut-out edge and the edge of the work surface.
- Step 1. Place the module in the desk cut-out.
- Step 2. Place the fixing point into the sliding cannal.
- Step 3. Place the L tighteners onto the fixing points.
- Step 4. Tighten the screws using Allen key.
MAIN FEATURES:
- Top Access is available in Black, White and Silver
- It is available in three dimensions: MIN, MID and MAX depending on the configuration.
- The module uses elegant, metal clamps that can be installed under the desk.
Available configurations:
G socket type:
- MIN: up to two sockets or tunnels
- MID: up to four modules or tunnels
- MAX: up to five sockets or tunnels
Other socket types:
- MIN: up to two sockets or tunnels
- MID: up to four sockets or tunnels
- MAX: up to six sockets or tunnels
Note: Use ABL’s Link, the accompanying under desk power module for the Conference unit. The most common socket types:
CONTENTS:
Note: Use ABL’s Link, the accompanying under desk power module for the Conference unit.
MAINTENANCE:
Do not open, disassemble, change, or modify the device. Every unauthorized opening or repairing of the device leads to loss of warranty. During device usage, you need to follow basic safety measures. since safety requirements vary, please check with local laws.
WARRANTY CONDITIONS:
ABL warrants this product as free of defects in material, design, and workmanship for the period of twenty-four (24) months from the original date of receipt of the product, unless applicable national laws stipulate otherwise.If during the period of warranty this product proves defective under normal use and service you should return the product to the retailer from whom it was originally purchased. The liability of the ABL is limited to the cost of repair and/or replacement of the unit under warranty. The warranty is void if a failure occurs due to the following reasons:
- Improper device installation
- Improper handling
- Improper transport
- Force majeure
WARNING: Do not use this product for any other purpose other than which it was designed for.
*Contact us for more information.
SAFETY NOTES:
- Items such as Vacuum Cleaners, Kettles, Coffee Makers, and Fan Heaters should not be connected via ABL power modules
- Installation is to be carried out by a qualified professional
Complies with BS 5733 (UK)
IEC 60884-1 and IEC 60884-2-7 (Europe)
Kitemark certified on 13A Plugs and Socket outlets (KM686563)
CONTACT US
UK DISTRIBUTION CENTRE
14 Fleming Close Park Farm Ind. Estate Wellingborough Northants NN8 6UF United
Kingdom
+44 (0) 1933 400 080 [email protected]
EMEA DISTRIBUTION CENTRE
Lava Tolstoja 25 32103 Cacak
Serbia
+381 (0) 32 420 100
[email protected]