e-conolight C-WP-A-FCA C-Lite Full Cutoff LED Wall Pack Instruction Manual
- June 5, 2024
- e-conolight
Table of Contents
C-WP-A-FCA C-Lite Full Cutoff LED Wall Pack
Instruction Manual
INSTALLATION INSTRUCTIONS PHOTOCELL OPTIONS
LOCATING KNOCKOUT
Locating knockout in an adjustable fitter:
a. Remove the wiring compartment cover from the adjustable fitter using a
Phillips screwdriver.
b. Using a hammer and a punch, remove knockout of wiring compartment cover.
See Figure 1.
c. See photocontrol installations. (On backside)
d.
WALLPACKS WITHOUT KNOCKOUTS
- Refer to mounting diagrams, Figure 2, for correct fixture series and drill an 11/16” (17mm) hole in the location indicated. Make sure the photocell will fit properly before drilling.
- See photocontrol installation
FIGURE 2
MOUNTING DIAGRAMS
PHOTOCONTROL INSTALLATION
- Remove the nut from the photocell, and leave the o-ring. See Figure 3.
- Slide photocell through the opening.
- Thread nut on to threaded nipple of photocontrol and tighten to ensure a waterproof seal.
- Wire photocontrol according to Figure 4 if wiring phase to neutral or Figure 5 if wiring phase to phase. In all cases make sure the photocontrol voltage is rated for the supply voltage.
- Reinstall any parts removed during the installation of the photocontrol.
WIRING
- Wire according to Single Phase Voltage or Phase to Phase Voltage.
Document: LPN00674X0001A4_A
Date 3-21-2022
Created By: TMT
www.e-conolight.com
888.243.9445
FAX: 262.504.5409
Documents / Resources
|
e-conolight C-WP-A-FCA C-Lite Full Cutoff LED Wall
Pack
[pdf] Instruction Manual
C-WP-A-FCA C-Lite Full Cutoff LED Wall Pack, C-WP-A-FCA, C-Lite Full Cutoff
LED Wall Pack
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>