e-conolight GKOLED LED Flood Light Installation Guide
- June 5, 2024
- e-conolight
Table of Contents
e-conolight GKOLED LED Flood Light Installation Guide
WARNING
PLEASE READ ALL INSTRUCTIONS BEFORE ATTEMPTING INSTALLATION
- To prevent personal injury or product damage only licensed electricians should install.
- To avoid electric shock or component damage disconnect power before attempting installation or servicing.
- This product must be installed in accordance with the national electric code (NEC) and all applicable federal, state and local electric codes and safety standards.
- Disconnect product and allow cooling prior to servicing.
- Any alteration or modification of this product is expressly forbidden as it may cause serious personal injury, death, property damage and/or product malfunction.
- To prevent product malfunction and/or electrical shock this product must be properly grounded.
- This luminaire is designed to operate in ambient temperatures ranging from -40°c to 40°c.
- LIMIT RANGE OF ADJUSTMENT TO.
- This product must be installed in accordance with the applicable installation code by a Person familiar with the construction and operation of the product and the hazards involved.
- In 75°c supply conductors.
- This product is not available for several special environments, such as places with corrosive gas liquids or high pressure water vapor.
Installation Guide
- Secure bracket onto the pole with screws
- Make electrical connections from the supply ground (L/N) lead to fixture ground (L/N) lead respectively, making sure to follow all National Electrical Code and all applicable local codes and ordinances
- Loosen screw to rotate fixture to desired tilt angle
- While making electrical connections, ensuring water does not enter fixture.
- Installation and service of luminaires should be performed by a qualified licensed electrician.
PHOTOCELL INSTALLATION
Universal voltage driver permits operation at 120V to 277VAC, 60 Hz except fixtures factory ordered with a 120V photocell (P1) or 277V photocell (P2) or 120-277V photocell(P0).
- Install photocell and wire as per diagram.
- Use photocell rated for your supply voltage.
TROUBLESHOOTING
- Check that the line voltage at the fixture is correct. Refer to wiring directions.
- Is the fixture grounded properly.
- Be sure the photocell, if used, is functioning properly.
WIRE CONNECTION
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>